Eastman 10737LF Quarter-Turn Angle Stop Valve, 1/4" OD X 5/8" OD, Chrome
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
This item was manufactured BrassCraft brands are made in the USA, so if you are looking for a better quality valve, check them out! The book is available through
Brass is the material used for the stem of the valve.
A fine thread might be an appropriate description. The angle stop is not the same for all. It is not worth the risk of a leak or flood in your house because you left the old nut and brass ferrule on.
The material metal
Selected User Reviews For Eastman 10737LF Quarter-Turn Angle Stop Valve, 1/4" OD X 5/8" OD, Chrome
In order to replace old multi-packs, I ordered several of these You need to turn the I attached the new valves to the existing nut and ring on the pipe in the places where I installed them without any problems. Tape made from Teflon did get used. It turns out that none of the four I installed leaked, so I am pretty satisfied. One thing remains to be seen is whether they will remain relevant over time.
well, but tightening it was much more difficult because the valve body does not have flat surfaces on which a wrench could be attached.
This product does not leak and is very easy to use. The multiturn valve is used to shut off a toilet.
It is very easy to install the pressure washer. When you need to shut off the valve quickly, the half turn ball valve comes in handy. The light must be off or on because you cannot doubt it.
There was a little bit of a snag in the chrome plating but this is a true ball valve that uses a steel ball instead of a plastic rod as the actual valve mechanism thanks to Amazon I received this product quickly.
No leaks and easy to use.
I am very pleased with the results.
Purchase of this kind is a repeat.