Yonico Router Bits Set Roundover Edge Forming 6 Bit 1/2-Inch Shank 13622
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
This is something you would like to run much quicker than a shaper can do. But you'd need to tweak the feed rate in a shaper if you're going to use them there. In any case, the cutting is more efficient if you use the recommended speed, which a shaper is not able to do.
It covers any defects that are the result of the manufacturer. This is when something is not done right or fails before it is finished. Bits will not be covered for ordinary wear and tear. Wear and tear on bits is normal, no matter what they are at. In the event that there is a real issue with the product, we will stand behind it 100%. If there is not an issue, we will not accept return. Whether you need help or not, we're always here to assist.
I believe they are meant to be used for cutting wood, so you might try it on an old scrap piece.
My shanks were always at least 1 inch long, and I never had an issue with them being too short. However, I recommend spraying yonico bits with bladecote on a regular basis they tend to become dirty quickly, and this keeps them clean and allows them to cut more
Selected User Reviews For Yonico Router Bits Set Roundover Edge Forming 6 Bit 1/2-Inch Shank 13622
It's been a while since I last used a circular saw For a while now, I've over looked this set, but I'm glad I made the right choice now. The pieces have been used so far and I am happy with the outcome. I have not used them on hardwood yet but I am confident they will work well. I will update this review when I am finished. This is a fine piece of music A boxed set has been made.
It was a round over bit that I was looking for. Purchased the set for the same price as if they had been bought individually.
The blade is sharp, the price is great, and it is made in the United States.
I spent a lot of time researching what bits to buy that would perform particular tasks on that surface, though because they are so expensive and since I was only doing one job, I thought regular carbide bits could do some of the work. A bullnose edge over the overhang and the backside- Edge of the splash. These did not go into the sink cuts - As I hired a pro for this job, I did not have to cut out or undermount the overhang. The use of this brand of router bits was highly recommended on the router forums and they were a fraction of the price of SS They were used by me and the results were satisfactory They did a nice job and stood up well to a challenging environment This allowed me to cut the SS without any issues and to leave a smooth edge without any If the project is primarily a DIY project, then I would recommend these as an alternative to the high priced bits.
I had to return items in exchange for 1/4" shank bits good service and product.
I've used both on hard maple and purpleheart and they both work very well. The next time I buy from Yonico, I will do so The hobbyist finds this price to be reasonable.
The product arrived on time, was well packaged, and I can tell the router bits are of good.
It comes with an extra pilot bearing and wrench as well as a cool little wooden case. You guys are doing a great job. This is true of the value as well.