TayMac MM710C, 4 3/4-Inches Deep, Clear Finish
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
Although I am not certain of the model I have, it is certainly deeper than that of It is 2 and 3/3 inches long. As long as there are only two models, then I can have the 4-foot 3 1/2- 4 It is a model measuring in inches. The weatherproof box that has the pivoting, liftable cover over the GFCI safe receptacle has been installed with a double GFCI safety **I use the socket on the lower side as a semi-tight socket Water fountain that runs on permanent power and has a cover that keeps the water inside in case of rain, and has a power line that runs from A temporary power tool socket is accessed through the upper socket when the lid is lifted. Due to their heavy weight, the plugs and lines on the heavy electric extensions take up a lot of space, so I needed the 4-foot cord instead 3 1/2- 4 They can be comfortably accommodated under a cover of one inch. In this case, an 18-inch screen would be sufficient Extension of the 2-foot gauge The second third- In most cases, the 2-inch model will be adequate, but if you plan to use heavy extension lines, I highly recommend the 4-inch version 3 1/2- 4 It is a model measuring in inches. A waterproof caulk between sections or around joints would also be a good idea.
What the question asks is not clear to me.
I would say you have only one, based on what I can measure. I measured it from the center and it is 25 inches wide. This product is definitely wider inside than the 2" overall width.
As a matter of fact, it It is easy to remove and install the new screws once you remove the screws for the old ones
Selected User Reviews For TayMac MM710C, 4 3/4-Inches Deep, Clear Finish
During the past year, I have replaced my 20-inch The year is We replaced the outdoor outlet covers from the old house with a couple of these Taymac In the event that you are considering one of these covers, you may have noticed that there are several options available in terms The three products I've used have literally been the best for me and I'd recommend them all. A 5" outlet is best for those who just want an outlet for some casual use, maybe for a few days (or at Christmas) if it stays plugged in. are 14 or 15 years old The ages of 16 and 17 Regardless of the type of power cord, the gague system will work fine with either system. The "5" or "4" would be better. A 75" cover is required. It would be better to go with the latter, although a 12-inch TV would be most convenient. The power cord should be thicker or of a stronger gauge. I have tried using a variety of extension cords on it, but none have been successful in closing the 2" version. is designed to fit most outlets in both vertical and horizontal configurations (in my home, my arrangements are horizontal). It is provided with a few parts that help it fit most outlets. This is a great idea, as it will keep the plug dry and ensure that your breaker stays on (safely) throughout the.
The problem with heavy duty cords is that they tend to have more robust casings at the receptacle end and it is very hard to find a cover that will cover them completely. As far as I was concerned, it was perfect. Watching some YouTube videos and reading the instructions contained in the package made the installation simple for anyone willing to do the job themselves. Although this product has a deep level of complexity, I have given it only 4 out of 5 stars because it is overpriced. I was surprised to find that the lid is fragile, as the plastic is sturdy, but it appears to be sturdy nonetheless. The tabs must be handled very carefully so they do not break.
As I use a few Etekcity Wireless Remote Control Outlet Light Switches from Amazon outside where there is a lot of weather, I recently installed these TayMac super-reliable remote controls My electrical outlet and the extension cord or power plug to the lights and garden fountain would be protected against the elements and meet code if I had deep wet use receptacle covers. It was necessary to twist the power cord up and down several times to get it out of the opening at the bottom, but all is well.
THROW IT AWAY! In order to align the male hinge to the hole, first align the male hinge. Put the bottom male hinge into the hole a little bit, align and screw in the other hinges to the holes, then take a small screwdriver and jam in the middle male hinge, and all the time make sure to hold the door snugly to the base. Once you jimp one of the middle hinges (even just one of them), the rest of the hinges will magically appear and you're After spending two hours on it, I finally learned how to do it. My experience is with installing sprinkler systems from scratch with complex construction, I ran ethernet wire through my house, and I have done a lot of other things, so please do not The design and marketing of this device is a piece of junk because the idiots who created and sold it did not consider it necessary to post a video showing how to assemble the stupid cover plate. In the instructions, "SNAPS INTO PLACE" is stated. Oh my gosh, that's true? In what way?.
As a provisioning measure and in case of a code violation, I purchased this to cover a 220 30 amp outlet right behind my hot tub just for peace of mind. Only three types of merchandise were on hand in the stores. The cord was too narrow to bend to bend the power cord. Anyway, it was more insulated than expected for a secure fit and it already had a bend. All you need to do is loosen the outlet screes a few turns, slide it in, move it over, and tighten it I found it really easy to put together. The door can be hinged up and down as well as left and right. There are plastic inserts to make it fit any outlet and tabs that can easily be snapped out for a large outlet like mine. My guess is that this is a solid, strong fit because it took some pressure to snap on. This is actually about a four out of five. A 8. 5-star rating is due to the fact that you aren't able to snap a hole into the plastic cover of the door AND leave the cord plugged in at the same time. This is what I meant when I took the picture. It will be a notch out for me. Usually this kind of hole only needs to be cut if one has a hot tub however, if you have anything that has to be plugged in constantly, and one uses a large power source (220), then you should plan on drilling.
Because the screws were going through the plastic holes in the black box component, I had to use shortened screw anchors on the drywall to prevent that from happening. In fact, I had trouble clicking the lid into place and believe that excess force or pressure would have broken the piece of plastic. As far as the sealing of the box is concerned, silicone will be used. The remote control adapter fits perfectly in the String lights will be used on this outdoor area exposed to elements. We didn't want to always have to unplug and plug in the cord. Does indeed work for that purpose. It's not bad at all.
In a nutshell, You can see a video of a post-installation demo. One star had to be taken off because for what it is, the price is a bit high. The plastic connectors on the housing are rarely broken when the door is mounted to the housing, and it would be surprising if it ever has been. This is a pair of rectangular plastic containers. I like that it is a straight plug, but the bent cord where the plug meets the cord is not to my liking. I think it is the best option I have seen, although it is probably cheaper at Lowe's.
They were so fragile I was sure they would break, so I just sent the thing back and looked for something with a real "Deep Clear Cover". This is both painful and inexcusable that the images and descriptions on Amazon are not Definitely a better way to cut down on the senseless, costly, and inconvenient process of constantly having to return junk. This is just a joke (taken from the web).
Related Products For TayMac MM710C, 4 3/4-Inches Deep, Clear Finish
