306A Pro/Tran2 30-Amp 6-Circuit 2 Manual Transfer Switch with Optional Power Inlet
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
As long as you do not exceed the maximum wattage the generator is capable of producing, the generator can work. In a 240 VAC system, 120 VAC is required on the X and 120 VAC is required on the Y inputs. The 120 VAC generator simply needs to be able to bridge or run in parallel with both of the inputs. An old car is for sale In the event that you are uncomfortable making the cable yourself, you can purchase a pre-made cable from Amazon.
A generator should not pass back any power to the utility grid if it has been installed correctly ( by a Licensed Electrician ).
Electric furnaces and electric water heaters are not intended for use with this product. This is basically a branch circuit that is 120 volts. Two circuits are connected to the living room, three to the kitchen, and one is connected to For the furnace to operate, a gas burner or furnace would be necessary.
Featuring 30 pole breakers and watt meters, the 306a features a 302 pole breaker inlet. A watt meter is included with the 306c.
Selected User Reviews For 306A Pro/Tran2 30-Amp 6-Circuit 2 Manual Transfer Switch with Optional Power Inlet
In addition to two 110-volt feeds, the box can handle a 220-volt circuit when connected to two of the 110-volt feeds. As per the instructions, the 6 loads (circuits) need to be balanced. They both monitor two sets of breakers using two watt meters. A, C, and E breakers are displayed on the meter on the left. A 10-gauge bullet. ) This size wire should be connected via a terminal in the box. Aside from that, this is a very nice sub-section There are two panels in the.
I am not an electrician and the instructions say that it needs to be installed by a pro. The wiring within my house has been done by me a lot since I have had electrical training. I found the instructions very easy to follow and it is so easy to install. Turn off the power, use battery lights, and make sure all lights are battery powered.
Take a look at the videos and read the directions. After I installed the switch and trimmed the work, it took me about an hour to complete the project.
Within about two hours, the software was installed.
It is a good price for a good product.
I was able to install and fit everything.