Four (4) UCP205-16 Cast Iron Pillow Block Mounted Bearings - 1" Inch Inside Diameter w/Set Screw Lock - P205
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
I would like to know how far the borehole is. It measures My sincere thanks go out to you for reaching out.
This race is about 3/8in. thick, and has a hardened surface and a fine thread set screw such as a 1/428. Unless you crank it as hard as it can be, you'll have problems.
It is 4 meters between the center and the edge. The slot is an inch wide and about an eighth deep
Selected User Reviews For Four (4) UCP205-16 Cast Iron Pillow Block Mounted Bearings - 1" Inch Inside Diameter w/Set Screw Lock - P205
To reload my firearms, I built my own wet tumbler using these block bearings. have worked perfectly and I have not had a problem with them overheating or freezing up during run times of 3+ hours. I would still buy these again for another project similar to this one, even though they weren't pressed in square and I had to adjust them myself to get my shafts to line up properly.
For the past two weeks, the bearings have been rolling nonstop. Purchasing more should be on your agenda.
This product was bought for a project when I received it I found the bearings had quite a lot of movement, but I didn't need precision, so I was fine. It was the diameter of the inside that caused the problem. The diameter of the inside diameter of these rods is only , but I need them to fit a one inch shaft. The shafts had to be turned down to make them fit the 998, which required me to narrow the shaft.
Smooth and sturdy, they have a nice feel. I plan on using these bearings for my future builds because they are easy to install and of a great quality at a great price. I think you're doing a great.
I got my order quickly and the product was good. I liked the price as well. Thank.
It looks like it is made the same way as other products I was paying much It was a pleasure dealing.