Jeremywell 2 Piece- 1 inch 2 Bolt Pillow Block Flange Bearing, UCFL205-16, Self-Alignment
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
I. What it is all about. Twenty-five years old As far as I remember, it was about 5"
I would grease the grease fittings since they have grease
It is the rotating ball bearing assembly that holds the center section with the locking set screws in place. Thus, the center shaft is relieved of stress, thus providing self-aligning relief. That is, i.e. In order for the shaft between two flange bearings to be perfectly parallel, those bearings must not be perfectly aligned.
Apparently it is rated for 3400 maximum rotations per minute in the description
Selected User Reviews For Jeremywell 2 Piece- 1 inch 2 Bolt Pillow Block Flange Bearing, UCFL205-16, Self-Alignment
To replace the auger bearings in my Snowex spreader I purchased these parts. Since they are constantly covered in salt and calcium chloride, it goes without saying that they are not in a very friendly As of now, they are holding up A report will be made in the spring if there are any Since I usually spread about 125 tons of salt in the winter, I'll have to make sure that they're in good shape.
These bearings are nice at a good price, but they are not being used for a motorized application at high speeds, but for a rotating compass needle on an art project, so there is no demand. While I work in the HVAC industry, these bearings don't look any more complicated than the expensive pillowblock bearings that we use at my company.
The only problem I had was mounting it into a tube that was 1. 5". In making an axle for a trike I bought bearings 1" in diameter, measured the inside, and the outside. I bought a 1" tube that was 1" longer than I expected, so I ended up with a 995" tube. I had to grind off a little on the outside because the outside was only 0. 5".
The two seem to match up and are made of good quality. The answer will be revealed when we are together on gokart.
It seems well built, but only time will tell how well it performs. I needed a new steering box support bearing for my 99 Dodge 2500 and this fits perfectly.
It looks like it is built very well. You can also grease the fitting and there is a little cover for it on it. I would buy it again if I had the choice.
As far as we can tell they seem to be well made and sturdy
So far there hasn't been any slack in their operation.
I am satisfied with the measurements inside. The right fit and the right diet It has a good finish. In this case, the shaft sleeve (race) measurements are on target.