Nickel Anode-1 Inch X 6 Inches X 0.04 Inch (19 GA)99.6% Pure Nickel Electrode Sheet for Diy Nickel Plating and Nickel Electroplating, High Purity Nickel Electrode
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
One plate is all that is needed for plating. To be plated, the nickel anode is connected to the positive terminal of the power supply and the negative terminal is connected to the piece to be plated. For the process to be completed, electrolytes are required.
I agree, it works In order to make it shiny, you'll need to polish it after it has been plated. You're on the right track with this!
Although this is a solid, little plate, it was not intended to be used with thin sheets. The manufacturer can provide you with a "foil" type sheet or you can find them elsewhere. When it comes to electroplating, this would be a great anode to use.
There is no difference between the two except that the shine is better. As zinc expands on contact with nickel, and nickel is more durable on contact with nickel. Your choice of nickel plating or zinc plating depends on the type of item
Selected User Reviews For Nickel Anode-1 Inch X 6 Inches X 0.04 Inch (19 GA)99.6% Pure Nickel Electrode Sheet for Diy Nickel Plating and Nickel Electroplating, High Purity Nickel Electrode
Nickel is nickel, and yes, it is going to last for a couple of times before it will be nothing more than some little chunks at It would be good if the anodes were thicker. In addition, I tried an 8mm round bar for six days and it lasted only six It lasted 4 days after I cut it in half. However, I leave mine running 24 hours a day. My plate needs to be thick so that I can polish it to a higher quality than other people can. A plate thick enough to cover an object the size of a basketball can be used. In the following weeks, the plating will progressively thin out. It is possible to polish off thin layers of plating. The truth is that I am a jack of all trades and not an expert in this area.
There is a revolver with a 38 caliber. order to plating, you need very pure metals More than 5%). There was no obvious impurities in the solution as a result of this process. It is ten out of ten. I will buy it.
It can also be used to plate the steel later without any problems. This nickel bar worked as advertised, you can find great videos on YouTube on home plating options. The purity of the water is not in question. A) According to the documentation, is 99+% pure. The main thing was that they did their jobs, which may or may not be accurate. Easily cut in half (both an anode and cathode are required) and, for me, drill holes through which the power wires can be attached.
The product delivered what it was supposed to. After it was done, I had a very nice nickel plate on my set up, as good as it could get. It was possible to create an electrolyte by cutting the product in half and using it as both anode and Despite its thickness, it was not difficult to cut with sheet metal cutters or aviation snips. Overall, I am very satisfied with the product and would recommend it to anyone looking to start DIY nickel plating! It can be exciting and it will look great!.
Sorry about that! Electroplating was going to be done with this. Whenever I try to magnetize pure nickel, the magnet is not drawn to it. It is made of stainless steel (304), which is low grade stainless at best, with a slight rust on the bars. This is indicative that there is iron in the steel and also it is low grade.
Plating can be done with nickle from this source. Aside from the cost per ounce, I am unsatisfied with the finish and pitting on this bar. We are planning to buy in bulk from a real electroplating warehouse as soon as possible.
A job.
For some zinc coating, I picked up a pair of these. Those worked just fine, in my opinion.