Litorange 2 Pack Heavy Duty Brass Replacement Control Needle Valve 1/4" Female NPT X 1/4" Female NPT Connection
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
Up to a certain point, it is dependent on pressure. Though the actual inlet isn't very high, it can't be very high. Down inside the male, there are openings for outlets. There are only about four female sides to these valves. 35mm
They have a lot of free time on their hands. o- rings in case the original o- rings are lost or broken When the ring begins to leak, it is a sign that something is wrong. They go on the needle valve's shaft, under the nut that secures the needle valve to the valve housing's body. They aren't for the threaded ends that connect the valve body to the piping.
Yes, I use them after my regulator to regulate the flow of gas into my forge.
Although the answer provided is technically correct, it is recommended that the packing gland be installed on the low-pressure side of the application. If you can see the valve spindle, you're looking at the low pressure side, according to Dan Rowe.
Selected User Reviews For Litorange 2 Pack Heavy Duty Brass Replacement Control Needle Valve 1/4" Female NPT X 1/4" Female NPT Connection
I'm using them to adjust the main air line from the compressor before it splits into eight lines in hydroponics tanks. They're well made, heavy, and easy to adjust needle valves. I tried using a regulator, but the pressure was so low that it wouldn't stay adjusted; I also tried using plastic irrigation valves, but they're just too finicky. This appears to be working.
It's just an on/off valve in my case. In my application, there wasn't enough space for a ball valve.
Even on low, my little portable grill was getting too hot, so I installed this valve to reduce the flame. I'm ideal for the job I'm doing.
It appears to be in good working order. I'm pleased with how they've turned out.
It's a very nice piece of furniture, and it's well constructed. I used it on an air brush with an air pump set to 80 psi and it works perfectly with no air leaks. I'm not sure how much psi it can handle, but it maintains an 80-psi pressure all day.
Or both. Both of the valves are leaking. A lot. When you're using these with propane, this isn't a good thing. Also, one valve would not move right out of the box, so I disassembled it to figure out what was wrong. The valve stem had become stuck in the seat. I was able to free up the valve, but that doesn't change the fact that the seals are insufficient for only 20 psi of propane pressure.
The solution was found in this valve! br>It's beautifully made of brass!.
One is productive, while the other is leaking. Because I'm using them for propane, the pressure is high; however, anything with a low pressure should work fine.