Pulldown Replacement Spray Hose for Moen Kitchen Faucets (# 150259), Beautiful Strong Nylon Finish - Sized Right at 68" Inches, Fits in Place of Moen 150259 & 187108 Faucet Hose by Essential Values

Although this is not a Moen brand hose, it can be used with it. Although the hose seems to be similar in design, the original Moen hose had a ribbed plastic hose inside the braid, which may have contributed to my original failure. The weight of the clamp on the faucet head resulted in the underlying hose cracking. Consequently, the new hose has a slightly smaller overall diameter (this won't affect the ability of the hose to move water). After it would no longer clamp securely on this new hose, I had to cover it with some electrical tape just below the weight position. By going around the hose three times, I was able to keep the weight from sliding down to the bottom of the "hoop" when the As a note on weight placement, the weight should be placed on the "upward" portion of the hose, i. e. the end closest to the ground. The pipe is positioned directly in front of It makes more sense when you install the hose to secure the weight on this side of the hoop. If you do not secure the weight, it will not fully retract. Lastly, note that this hose DOES NOT contain the two rubber orings required for the faucet head to be sealed. If you throw them out without pulling them out, you may damage them. Inside the faucet threads there is an oring, and inside the threads of the new hose there is another oring. If you use a small flat blade screwdriver, you can get it out using a toothpick. You will notice that the faucet head leaks badly when you turn it on if you do not install these. In general, this hose cost half the price of the original equipment manufacturer version. It only makes sense to see how long it lasts, I've only got 3 years left.

Oaklee Hughes

| Aug 16, 2020

The Pulldown 150259 hose for a Moen faucet we bought from Costco four years ago is still working fine. It developed an unseen leak somewhere along its length as was the case with the old one. I like this one better than the OEM because it is longer and the ends look good too. The spray end is referred to as better. As opposed to casting lines, the metal casting has a totally smooth finish. This is a small A lighter, more flexible hose, it bends easier as well as is lighter and more supple than the previous one. In my tests, the diameter did not appear to be that different, and the weight clamped on with no issue. It was noted by another reviewer that the O- would need to be reused As the new model does not include a ring on the spray head, it is not included on the new nozzle. As time passes, it will be clear if it will last, but for now, everything seems sound.

Alec Boyle

| Sep 20, 2020

HOWEVER, the SOCKET the hose plugs into also started to leak on the opposite side, and the connector is permanent under the faucet. As I didn't want to replace the entire faucet set, I cut off the socket from the top side and used extra tubing and hose clamps to make it work. As part of your replacement aftermarket option offering, I would like you to also make available (sell) a replacement aftermarket socket and tubing that would be installed with two clamps once the old socket has been disconnected from the.

Lexi Aguirre

| Jul 23, 2021

I had installed an original hose which was leaking and at risk of failure. In addition to replacing the original hose with this product, I also bought this. I agree the product has an inexpensive price and is easy to set up. In comparison with the old Moen that was on my sink, the diameter of the new hose seems a tiny bit smaller. Although all adapters fit as expected, they all fit snugly. We haven't had any leaks or problems. The quality of the video appears to be well, but not quite as good as If you don't know how to install it you can watch YouTube videos. I had it all figured out in no time. The process of installing the part only took a few minutes once I had the correct part. The product I purchased from the big box store was not available. I am glad to have gotten this product. The most common type of sprayer is the side sprayer or pull out sprayer. You'll know exactly what I mean if you've been to a big box store to look.

Bexley Barton

| May 21, 2021

I like how long it is and all the plugs and sockets work The screws go in easily, and it seems Since I have only had it installed about 2 weeks, I cannot comment on its quality or durability at this point. The cons are There is less skin on this hose compared to the original It is obvious that my weight under the sink slid down to the low point as soon as I put it on. In my opinion, this is a significant problem for two reasons Firstly, enter 1. After pulling the hose out of the faucet housing, since the weight is not higher up on the hose, it makes it difficult for it to easily go back into place. Initially, it will dangle and you will have to force it into the first socket. In this case, you are unable to pull out the hose as long as you want. Having that control so you don't accidentally move the faucet outside the sink area may not be a deal breaker for some, but it's nice to have. As a result, I will likely find a way to keep the hose attached between the weight and the weight.

Elena Mejia

| Sep 28, 2020

This saved my life (try doing without your kitchen water supply! I didn't give it 5 stars is since the conical piece that used to be 9/16" is now a little larger, so it doesn't fit in as well. A little droop has happened so the faucet isn't as sturdy as it used to be. We were delighted that it didn't leak, so we were very satisfied. Could they have beefed up the curriculum?.

Jaxtyn Foster

| Feb 06, 2021

In order to replace my old kitchen faucet, I bought this item. Having spent a few hours reading reviews and using search engines to find this product and comparing it to others, I made my decision. Originally, the description, which matched what I needed to replace, couldn't have been any more accurate. After installing the new hose with ease, I literally detach the old hose in minutes. It is recommended if you want to replace the product, but you do not want to replace with OEM, as this fits the bill and has the same durability!.

Aspen Booth

| Sep 19, 2020

In the process of losing. Despite these differences, the hose, threads, and fittings look exactly the same. There is no way to tighten them. My Moen seems to be too loose for them. That's awful. I had to wait for the holiday weekend to get it, and it was a bad experience. One of the most frequent issues with Amazon is delivery. There should be one here today, I will search locally for one.

Edgar DODD

| Nov 14, 2020