WEN 4227T 13-Amp 12-Speed Floor Standing Drill Press
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
Several details from the top of the base to the top of the chuck, it is 45 inches, and from the lowest setting of the platform to the top of the chuck, it It may help to know that.
Due to the fact that I have a 4225, I cannot speak specifically about its capabilities. I moved my table over so that when I moved the chuck to the side, there was about five feet between the bottom of the chuck and the base of the table.
Seven inches and a half
Selected User Reviews For WEN 4227T 13-Amp 12-Speed Floor Standing Drill Press
Using an LED display, we can see the RPM.
Since I have had this drill press for almost 2 years now, I have continued to enjoy its use. There is only one drawback that I have discovered, and that is that the bolt slide grooves in the table are different from other drill presses I've used, so I need to purchase things like V-blocks again. Tools such as blocks, vises, etc. When I make suspension parts using a carbide hole saw, the holes are very accurate, and they enable me to slide bearing races or bushings into them perfectly. With the help of casters, I made a carriage for the press that makes it mobile.
It's great to have a drill press so good. For metal, I have been using it at the slowest speed and it works well. During the purchase of the keyless chuck, I also purchased a replacement key. Lie on the ground with the head on Before attempting to stand up the head on your own, lift it up with a car jack to an elevation of 24 to 30 inches. If you're trying to put the head on the base on the floor, use a moving floor dolly. By placing 3/4 inch black pipe over the tension release, you can change the speed. i love the drill press and that it is a good purchase for the price. As expensive and heavy as the powermatic was, I had given it up years ago. I can change chucks in a few minutes if necessary with the aftermarket chuck. I had run out issues before the aftermarket chuck was installed. When installed into the Morris taper shaft, the original Chuck has run-out issues, it seems like it was not properly aligned. Whenever you buy an aftermarket chuck, make sure you buy the shaft and chuck at the same time A aligned alignment.
I found this heavy duty box to be very well packaged, as it was strapped directly to a The truck arrived on a special lift gate to ensure that it could be unloaded easily. I took it down in pieces as I had to work from the basement so I had to lift pieces up. All pieces fit quite well and assembly was very straightforward. Another person will likely be needed to help you lift the motor/head to the top of the pole. As soon as I called customers service in the 800 number, they sent me a free replacement laser. It was simple to replace the dim laser. You just had to remove the task light in order to access the wires you needed to cut, and then connect the two wires to.
This is a very heavy duty product. I like the size of the Running my unit is quiet and I have very little runout. It is possible to change the speed of the belt by switching pulleys. In my opinion, that method is more efficient since it enables me to have low rotation speeds. There was a significant drop in the units with digital readout. When you pair it up with a nice 2 axis vice, you have a very valuable tool for your workshop.
The pieces are extremely heavy you will need help to put them together. I had a hard time putting them together by myself. My order was on back order for a while, but I was glad I waited.
It is as nice or nicer than any other drill press I have used in my past professional career as a machinist. This is a great product and I would definitely.
The drill press is excellent for the price. Wish it came with automatic belt adjustment, but manually adjusting the belts isn't so bad and it isn't as complicated as I expected.
Related Products For WEN 4227T 13-Amp 12-Speed Floor Standing Drill Press
