Quick Set Drill Press Hold Down
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
is meant to fit in holes in the drill press table and not the table the drill press is attached to.
An M10 is a machine gun. The ACR Hard copy is 5".
I can wear it with my 10"- 13" shoe A properly fitting holddown is based on the diameter or size of holes on the drill press bed so you can screw it in firmly.
Please provide the following parameter values From the center of the shaft to the center of the rubber hold of the arm - The down foot is equal to three. The 30" (a little more than 3 1/4") is a little shy of the 3 1/4" mark. A rubber shaft is attached to the- Alternatively, you might be able to use a horizontal arm extension to hack a longer reach if the clamping pressure didn't have to be very Approximately 4 3/4" clearance between the worktable and the bottom of the rubber hold is provided by the shaft of the clamp. I put my foot down. There is no plastic on the clamping lever, which is made of industrial plastic and is well made. In my experience, it has been useful for those who are close to the situation This is useful for jobs where different clamping heights or locations are required throughout the build (I have two of these). It may help to know that.
Selected User Reviews For Quick Set Drill Press Hold Down
The product appears to be well made, simple to use, and Its functionality has not been found to be lacking so far, after using it on two small projects. As it stands (with the addition of a wider fender washer underneath) I am using it on my drill press, but it appears that it can be easily modified to accommodate the attachment of other surfaces to the drill press worktable. A hold-up could also be This rubber foot is attached to a standard 1/4" shaft It is possible to swap downs for ups. I am satisfied with the end result, all in all.
I do not have anything bad to say about it. It is placed on the top of my drill press table. The clamp is adjustable and very tight. Compared to other online retailers, it takes a long time to receive your order, but the wait is well worth it, in my opinion. I am happy with the quality of the product.
There are few drill press clamps that can compete with this Wood River clamp. There is no comparison between the high quality craftsmanship of this tool and those of those found overseas. Despite being rugged and easy to clamp, it is also extremely easy to position and adjust.
As I was trying to clamp things to my drill press table, I ran into some problems. There's just no way to clamp wood well in that case with regular clamps. I think that this is the best This clamping force can be adjusted and it holds materials ranging in thickness from under an eighth inch to more than three inches.
There is a lot of value in this By using this clamp, you don't have to make a 'c' clamp or another type of clamp to use on the drill press table, saving a lot of time. Also, I purchased the large rubber foot pad, which has proven to be very helpful. It is good to be.
Having this drill press has been a great addition to my shop. Due to a little disappointment with holding power, I gave it a four star rating. The quality of our work will be excellent if you are doing small to medium projects.
I would recommend this product. It works just like it says it will. The finish is good, and the operation is smooth. The mechanism holds tightly, yet releases easily. What a mess! Basically, I purchased this hold down before losing my finger and never have to worry about it again.
I bought two of them. I removed the finger tighteners and drilled and taped two pieces of steel to be placed under the table. I can't find a problem with it.