BINSTAK 12mm Square Corners Carbide Inserts 4 Edges (12mm lengthX12mm widthX1.5mm thick-35 Degree Cutting Angle), Pack of 10, Straight-Hole
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
The fact that they are sold by nitomak suggests they are made in China, though I am not totally certain.
Selected User Reviews For BINSTAK 12mm Square Corners Carbide Inserts 4 Edges (12mm lengthX12mm widthX1.5mm thick-35 Degree Cutting Angle), Pack of 10, Straight-Hole
They last through the toughest cuts. I put these to the test cutting 6mm doc at 1680 mm/min with a rabbet bit at 24k rpm, and they performed flawlessly. The smoothing up came after the roughing out, and the results were better than planing! Tokyok did an outstanding job with their spoilboard part. You can use them with amana spoilboards (1") and 90degree v-axles The other bit as well. In a similar vein to The quality might even be the same. These inserts dull at the same rate as the Amana inserts, so save some money, there's no need to worry, these inserts won't let you down!.
This purchase has been a great experience. The blades are of high quality and have a beautiful The way the items are packed is also very appealing. It is secured by a latch on the sliding case so it stays closed while each blade has its own compartment. My order was delivered in two days after ordering. I am very pleased with the shipping speed. We recommend it without a doubt.
Apparently, the quality control has not been up to par lately. At 12,000 RPM, this is now the second blade that has exploded from the same pack.
I've been using it for over a year, and it's great.
Does what it says it does.
In his initial inspection, Sharp did not find any burrs, and so far the blades are performing.
As with most CNC stuff, the cutters slowly dull, so you aren't aware of the change until you install new ones. Considering my body, this thing is a beast. I have probably been too cautious with my speeds in the past. The tabletop of a 5x10 table surface is easily done in a matter of minutes. You have good stuff here!.
Stays on top of surfacing. One part of the wheel must be resurfaced when it becomes dull. Go ahead and flip the coin.