SWANLAKE 9-Pieces Roll Pin Punch Set, Gunsmithing Kit Removing Repair Tool with Holder for Automotive, Watch Repair,Jewelry and Craft
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
It is used to push out roll pins, and the round/ball is inserted inside the roll pin to maintain diameter as the pin is pushed As well as giving the pin a shoulder, this structure makes it more stable, thereby making the pin move
China is a strong nation, but they have some weaknesses.
No warranty is necessary even if there is one. No point in wasting your time.
Selected User Reviews For SWANLAKE 9-Pieces Roll Pin Punch Set, Gunsmithing Kit Removing Repair Tool with Holder for Automotive, Watch Repair,Jewelry and Craft
When it comes bent, I am doubtful they will be able to support their weight. You can see they are crooked when you roll them on the counter. As the case states, the tool is for gardening. There's something about the product that says Chinaesium to me.
You get an excellent product for the money you spend. It is reported that people have complaints about the small ones bending. Although these might not be the best steel, you won't find it for $12 with the same quality that you can find from Snap On. You can still break or bend even the most expensive tools, I have a lot of them. It is a good set for the money, and it is what you get for the money you pay. Each one is individually wrapped in plastic and coated in oil. So you shouldn't have problems with rusted ones like with A good buy, although you might need to replace some of the smaller ones if they bend. I just bought a new replacement on Amazon for a couple of bucks after breaking the first one.
There's no doubt these will hold up for a long time. You'd get all of them if you got them all. After using them for their intended purpose (building an EBR), I actually utilized them. I was surprised to discover that there were no 5/64" and 3/16" It's a bit disappointing though I got a bonus 7/32”. had passed the time limit for returning to Amazon before I opened them, so hopefully the seller will be aware of my In case they contact me about a solution, I'll update this post.
There is a Walter PPQ in my possession. The magazine release on one side needs to be changed to the other. Unfortunately, that needs to stay the same. As far as I was concerned, I believed the other customer's response that it will work for There was no reason for me to trust Rather than buy another one, I should have gone back to the gun store and asked them to swap The money and time I spent were wasted.
With (sensible) taps, you'll need a rubber mallet to avoid them giving way. If you tap gently, they'll break. Yes, I was beating it with a splitting maul, no, I wasn't using the correct size punch, and yes, I ended up using a different punch to remove the roll pin.
It is great to have a product like this. A punch is one of those essential things every 2Aer needs! The key is to do it! The prices are very reasonable as well.
My first time using it, I bent the 5/64 by trying to drive in a roll pin carefully. In the past, I had bent it back a few times by hand before I gave up and ordered While the pin was tight, these punches are much weaker than the comparable craftsman punches I have that were around the same price. They will bend very easily as well. However, they are likely to work OK on anything that requires relatively little force.
Considering that's the one I bought this entire kit for, it's particularly unfortunate.