6 Pcs Hollow Leather Hole Punch (Round Hole Punch Set) for Leather Watch Band, Leather, Gasket Belt, Fabric, Canvas Paper Plastics. Leather Punch(1.5mm-4mm). ASONTAO
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
A hammer is used to smash the top end of the punch against the leather after holding the punch against the cutting edge. In some cases it may be necessary to repeat or hit harder the punch the next time depending on how thick the leather is.
I think it will work because there are several sizes of the leather punch. So far I have only used it for making extra holes in my leather belts and it has worked perfectly.
In short, yes. There is a lot of strength in it. Punching through thick leather is something I do with it.
I think it is a great In my belt and dance shoes I can easily make holes with my needle and thread. I can make holes in leather and fabrics as well.
Selected User Reviews For 6 Pcs Hollow Leather Hole Punch (Round Hole Punch Set) for Leather Watch Band, Leather, Gasket Belt, Fabric, Canvas Paper Plastics. Leather Punch(1.5mm-4mm). ASONTAO
That I chose these over the squeeze type rotational hole maker is where I am happy with my decision. The use of these devices has been described as challenging in some comments I have seen. I used a belt hike maker for the first time and could not be more pleased. You will need to use a hammer on some surfaces, so make sure you are not damaging the surface. So as not to chip the countertop, I did it on a countertop with a small notebook under it. It is very easy to make holes. There will be a lot of tapping involved. While I was protecting the marble countertop from damage, I also wanted to avoid scratching it. In certain cases, you may have to just give it two or three good sacks if you are on a workbench. The belt hole punch should be placed on the good side of the belt. Here is a tip on how I made it easier To make a proper template, line up the edge of a piece of paper to the edge of your belt and press it so that it accurately represents the position of the Please look at the pictures carefully (I hope it made sense to you). that you know exactly where the new holes should be, you can dig them! This is what I did on the underside of the belt, but you don't need to do it. In the end, I just twisted the utility knife over the pen mark until it was just barely pushing through the belt. This did not make the hole I wanted, but it did make a point of contact on the good side of the belt, and I knew where to drill In fact, you can just mark your holes on the good side of the template paper with a pen instead. Just be careful not to slip and make an inaccurate mark, especially if your belt is light colored. Despite my apprehensions, the process was relatively simple and quite enjoyable!.
A 0 mm punch is used to punch holes through leather to make bow stringers. The hole that I attempted to make in 3 was a success. Examining the four, we find that they are all correct. Upon looking at the hole of a 0 mm punch, the cutting edge extended only a quarter way around the hole the remains of the edge were To keep the punches and sharpen the four, I will keep the punches. I might be able to get it to cut with some fine tuning. As for the appearance of the punches, the ad picture and what I received are not the same. Having used these punches, I would not recommend them.
With this set, I purchased some silicone watch bands so I could punch some holes in them. The surface of silicone is very "spongy" and in no way similar to Fortunately, I was able to achieve my goal with leather, but it took more hits than it would with canvas. My experience with the product has been very positive.
I've been using these punches for years and they look so much better than the holes I had to make with the A lot of time could have been saved had I purchased.
Use a drill on cloth to get a great result.