HHIP 8600-4120 Optical Punch Set

About 4 power seems to be enough. However, the most important part is this the image is extremely sharp, with a crosshair that is very fine and is drawn on a pencil line. The cross hair on the pencil line covered by a 3mm pencil uses a 2H lead but I have no problem seeing where the pencil line is or where my tick mark is located. Once I get the cross hair to show, there is no problem seeing the pencil line. As the punch was centered on the tick mark, I put it in the socket and the result was a center-tick mark In conjunction with the line and tick mark, the punched mark is located exactly where the two intersect. The center-to-center distance is still narrow, even when working on steel that is soft There is just enough indentation on the punch to keep the drill bit from wandering in the wrong direction Coursework required. If I tried it on steel, I would not be successful If drilling that kind of metal, it is probably a better idea to use a drill press and a drill press vice to hold the metal and the mark may be made with machinist blue layout fluid and a very sharp tungsten scribe versus

Right now, we are unable to supply replacement punches.

With one lens and one punch, it comes with only.