2 Packs W10195416(Upgraded) Lower Dishwasher Wheel Part Assembly Replacement for Maytag/Kitchen Aid/kitchenaid/Whirlpool/Kenmore Dish Rack Replaces AP5983730, W10195416V, PS11722152

I ordered the replacement wheel. My motorcycle is back in order now that I've replaced the wheel. I was able to install it easily and fit it just as described.

Emmie Chapman

| Aug 06, 2021

I love getting things working again like they were new. I really like the look of this and it looks like it fits my dishwasher quite well. During the process, I watched a video which basically described which part of the old part I needed to press into the screwdriver edge for it to pop After a little bit (10- 15 minutes), I was able to do it Probably took 15 minutes or so to get the old one out and the new one in, but what a feeling The following is a serious statement.

Canaan Moyer

| Aug 19, 2021

We were able to get the product at a reasonable price, certainly more affordable There was only one 2 pack, so I probably should have ordered a 4 pack. However, the other 3 did seem intact. I couldn't figure out how to get the old one out. Applying pressure to the bottom clips with a screwdriver caused the bottom clips to pop off by themselves. As a result of reverse pressure, the new one took less time to install.

Lian May

| Mar 10, 2021

I received my wheel part assembly parts two days after ordering. It made the KitchenAid site look like an ancient method. I have no complaints about the parts. It lived up to my expectations 100%. As well as being packaged very nicely and safely, they were packaged like electronics parts, but they were It is a vendor that I recommend to friends and family. Your job was well done!.

Aviana Valenzuela

| May 02, 2021

There is a video on Maytag's website that shows how to remove and install the We tried to make it as simple as we could. Likewise, the wheels looked exactly as they did on the original Maytag models. The originals lasted so long, now I hope the new ones will. As well as the price, it was reasonable. If you want to compare Maytag, go there. These are the ones I recommend.

Lennox Gonzales

| Apr 05, 2021

started with a wheel failure and has had a series of failures since then. While I was replacing the wheels on the Tiger, I noticed the lower spray arm was broken and wobbly. A collapse of the wheels during the cycle is most likely to blame. In the end I was unable to return these wheels by the time I was able to replace the scd, as they were not the same in several key minor ways. As a result, I compared the old and new when I replaced them. I completely missed the fact that the base to which they attach is different, despite the wheel size being the same! On these, the wheel setting is higher than that of the original Kenmore part (13222). The dishwasher lower rack has a slight incline to it, so while it's ok to use these wheels for the front, they're too low for the back and don't allow the spray arm to spin. As such, over all it was a waste of money that I could have detected right away if my spray arm hadn't.

Cameron O’DONNELL

| Apr 16, 2021

Our dishwasher rack wheels were broken so we bought this set to replace them. I was able to purchase this product for less money and came quicker than if I had gone through the The wheels were easy to put on and took just a few minutes to put I have no problems rolling my dishwasher racks!.

Kara KAY

| Nov 23, 2020

It is not yet clear how long these new ones will last since the old ones started corroding after less than 2 years. These new ones seem a bit more durable, Installing them was easy The rack snapped right into place, and they were off to the races.

Khaleesi Valentine

| Dec 21, 2020