Hammers 1inch One Piece Scope Mount with Stop Pin for High Power Magnum Airguns Air Rifles
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
As this is a scope mount, I'm not aware of any. A 1 inch diameter scope mounted within the fixture adjusts the windage and elevation.
Danny, my dovetail has a recess near the back of the rifle where the pin in your scope mount goes. My clamping plate was now on the gun's left side. br>I hope this has been of assistance to you!
I suppose it would if it had the standard dovetail?
Luke T. The manufacturer claims that the mount will fit a 50mm scope (the lens diameter), but the overall diameter will be slightly larger, most likely 56 mm. I took a 32-inch measurement from the scope's center line to the receiver's top. 33 mm. If the height along the top of your gun is consistent with the receiver height (i.e., half of the scope diameter is 25 to 29 mm), you should have less than 3mm clearance. You can add scope lens caps to increase the overall diameter of the objective end of the scope (include scope cap diameter) or you can put a rear sight block on the barrel, picatinny rails, ribs, and other things to make it stand up higher. It's going to be a tight squeeze. What is the actual outside diameter? Caps for the Bestek scope? If you know the measurement, divide it in half to see if it is less than 32 mm. If it's higher, it's a no-go.
Selected User Reviews For Hammers 1inch One Piece Scope Mount with Stop Pin for High Power Magnum Airguns Air Rifles
However, it is a very steady climb!.
So far, everything has been running smoothly. I used it on my son's Stoeger pelletgun. After a hundred target rounds, he used blue lmixture to secure it, and the scope is still holding zero. The stock Stoeger pellet stock x20 that came with it serves as the scope.
My Chinese B3 rifles' top mounting grooves were a 1/4 inch longer than the one-piece mount. Dremel tool was used to reduce the clinch edges to fit both ends of the base. The anchor set screw used to prevent fore/aft movement did not cause the mount to come loose, as it did with the two-piece mounts. The scope does not slide in the mount, and the zero is maintained. Well-crafted and finished product.
It's secure, and one of the stop pins is far enough back to fit the whole in my Walther Terrus, which is drilled as far back as you can go.
Rings and a solid base. Purchase them because they are of high quality.
Because the scope on my Marlin 22 rifle kept coming loose, I thought I would have to sell it. My problem was solved by using this scope mount, which included two extra screws on the side rail and one through the top. My scope is now securely fastened to my body. This is an excellent product, not only for airguns but also for 22 rifles.
Ideal for air riffles with a lot of power.
A good product with a sturdy mounting system. This is what I put on my Beeman spring-assisted bicycle. The scope has held its zero well so far with a high-powered pellet gun.