attwood 91017B7 Frosted Globe Screw-On Replacement Lens Cap for All Brand Lights, Silver
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
This is not a pair, only comes as a
In the Attwood Resources section, you'll find the Attwood Catalog 2020. On page 29, you will find a description of lighting.
The screw on cap is indeed screwed on. You can use it for attwood 360 degree light assemblies, but I am not certain what you have installed on your harris flote. There are several different lights out there, and you will have to confirm as there are different models.
You can reach Bennington by phone
Selected User Reviews For attwood 91017B7 Frosted Globe Screw-On Replacement Lens Cap for All Brand Lights, Silver
It is not described well on the physical side of the product. 2 inches is the height I measured her at. It begins with "0". A female thread with a diameter of 1 is incorporated into the interior diameter. It measures 513 inches at its widest point. While the light from the lamp will still be bright since the plastic globe is light, it is slightly milky and therefore should not distort the light. In comparison to the tall press, the globe towered over it easily. The voltage is 12 volts. Light is provided by an incandescent bulb. As for the rear pole lamp on my Harris pontoon, I was unable to determine what source supplied it. Although the pole lamp I had looked like an Attwood model, with a fluted shape to the base, I never really liked it. I ordered the 91017B7 out of desperation instead.
As you can see from the photo above, the opacity of the globe is not that of the photo. A scale of 10 is equal to what my picture shows, and 1 is clear. The globe I received was about a 3 at best. In other words, clear with a milky sheen. Since there will be no diffusion, almost all of the brightness from the bulb will penetrate the globe, making it much too bright and irritating to fish at night. This product is of great quality, just like the originals, and has a side wall It has a threaded base of approximately 090. There is a 130 and it fits perfectly. Because of its importance, I will not be sending my globe back. Probably by painting the inside of the globe or covering my led bulb with something, but I still have to figure out a way to make it more opaque. It would have been better for Atwood to replace these globes with originals.
It said it would fit all Atwood navigation stern lights, but mine was not compatible. The thread diameter was about 0. 7 mm different, but it was enough to make the lens inoperable and keep the light from functioning. I was able to get a refund from Amazon.
We expected this to be about what we got, except that it was a bit expensive. Hope it lasts longer than the last one, but we are not sure.
I replaced the anchor light on my 1984 boat after it had been broken for 35 years. I didn't bother trying to find another anchor light of the correct length that would work instead, I found this cover that appeared to lead to a good result. It worked just fine for me when I ordered it. Compared to locating another anchor light, we were able to save a lot of money and time.
I purchased this globe to replace the one on my Atwood Stern light. The clear plastic in this can't last more than a few years in Texas' sun, so this is the second time I've had to replace it. Trying to cover this one with an old black sock will see if that works.
The original copy is an exact replica.
I drove down the highway one day and started driving down the highway, where the car flew off. I just didn't want to replace the original light, and this seemed to be a good replacement. The product was not at fault for that. My next order will likely be the same one that I ordered this It could be frosted a little better, but it is behind me most of the time.