Moeller 035740-10 Deck Plate Fill

An outer diameter of 76mm is measured on the flange. It is 8mm from the outer edge of the flange to the center of the screw holes. An enclosure has three screws that are 52mm from each other. Please find below some information that may be helpful

As far as I recall, it was 3" but I'll let you know if the size is

See the picture before buying the item, and if it shows the part or parts that are shown, then everything The last time was four As I recall, and I believe I did, I did not purchase any additional items when I installed the intake deck plate fill. The only thing we attached to it was a hose going to our 5HP generator's gas tank. There might be instances where the included screws are too small for your installation, or if the stainless screws are not right. That's most likely the case. Also manufactured by Moeller was the 6 gallon gas tank (made from good quality plastic). As for the filling in of the deck plates, you will need to use caulking of your choice.

It was a perfect fit on the key, and the overall quality of the product was extremely good.