60 Pack RED xGarden 360 Degree Micro Sprayer Fan Jet - For Hydroponic and Aeroponic Misters and Cloners
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
The threading on these is NOT 10/32. DON'T EVEN THINK ABOUT IT. These are made to be used with flexible tubing. A 10/32 tap on pvc tubing (such as my clone king) DOES NOT FIT, despite the seller's assurances. IT'S A FAKE NEWS STORY! The threading angle varies as well. I squandered money on these, and my manifold was stripped of a few 10/32 tap holes. THANK YOU FOR MISREPRESENTING YOUR PRODUCT, YOU GUYS!
If you use the recommended drill bit size, it works great in PVC. I can't speak for rubber hose, but the spray head's threads aren't very large, so you'd need to poke a hole small enough to support the threads, or the spray head would shoot out if the pressure was high enough.
These aren't compatible with one another. Each micro sprayer has its own hose connection. end.
If the spray radius is the same (e.g., e.g., e.g., e.g There is no difference in the product if you rotate it 360 degrees, but some people prefer different colors!
Selected User Reviews For 60 Pack RED xGarden 360 Degree Micro Sprayer Fan Jet - For Hydroponic and Aeroponic Misters and Cloners
They perform admirably! It has a good flow.
I drilled the holes with an 11/64 drill bit and then carefully twisted in and out size 10-inch screws. To make the threads for my DIY setup, I used 32 machine screws. I used a 400 gallon per minute pump with six sprayers, and it worked perfectly. They worked fine even when I turned my pump all the way down. It's a good thing I did my testing in the shower because those things spray like crazy!.
This is supposed to be a 360-degree rotation. I tried a few heads and found that instead of a full even pattern, they were neither full nor 360 degrees. Instead of a uniform spray pattern, parts of the spray shot up into the air, some longer than others and unevenly distributed.
For proper spraying, good sprayers require a high GPH flow. I had to use no more than 4 on a 400gph pump and no more than 9 on an 800gph pump on a foot of PVC. Alternatively, they'd trickle down. Also, because these clog easily, make sure that no fuzzy from your pockets falls into the sprayer's feed tank.
They work, but every couple of pieces has a thread that is slightly off when I screw them into our aero cloner sprayer. They still function normally, albeit with a slight lean.
The ez cloner manifolds are compatible with this product.
When emitters are screwed in from the top down into lines, regardless of whether the water pressure is high or low, the spray pattern is dome shaped. 360-degree rotation for a specific height degree spray pattern suspended a line at the desired height with the emitters on the bottom. The spray has a sprinkler-like quality to it. Instead of fine mist, it's more like.
People who complain that they are fake don't keep them clean or don't use a powerful enough pump. SPRAY will be sprayed by these bad boys!.