Switch - Original Marshall, Rocker, Power for MG Amps, Black
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
The mg250 dfx worked just fine with it. If your Marshall has a switch like this one, then this would work on it.
The only thing we can verify is that it works with the Marshall amplifiers for which it's designed.
The power switch attached to this message applies to It is important to note that the mounting hole is 0mm. The dimensions are 51 inches by 0 inches. A 76-inch height. Thank you for your kind words
This will work, I've just installed one of them, although I did have to change the connectors on the end of the amp wiring that goes onto the switch, but it's a very straightforward fix, it works great, thanks.
Selected User Reviews For Switch - Original Marshall, Rocker, Power for MG Amps, Black
The installation process is simple The six screws at the top of the board are to be removed so the electronic board can be removed. With fingers alone, it's really hard to squeeze the switch box, so you'd probably need to use a wrench or something similar. Grab the clips on top and bottom, and you'll be able to release the switch box from the knob. After the 4 wires are removed, remove them before (or after) the fuses are removed. Taking off the wires first was the way to do it. You need to really wiggle them to get them loose. I have a hard time getting off, and I have an easier time getting Don't forget to label them or take a picture of them so you know where they go. Push the new switch in from the outside of the unit (you may have to apply some force to compress the clips again), and reconnect the inside wires. Be sure that there isn't any bare metal showing on the connection (there could be plastic sheathing The task has been completed in less than five minutes.
After a quick search, I found this switch to replace the broken one on my MG50DFX. My experience with modding or maintaining hardware is beyond my comprehension, however, after following the instructions on another review here (removing the six screws holding the amp in place and then removing and replacing the switch), I was able to get the switch installed and the amp working in less than five In addition, the switch got here a lot before the estimated time frame, which was a pleasant.
The installation of this filter on my Marshall amplifier was simple. The four screws on top of the amp need to be removed, and then the control board should slide The wire attached to the switch must be noted. You will have to pinch and remove the old switch, remove the connectors, run the connectors to the new switch through the hole, and install the switch into place by pushing it into the control board. It will then need to be reverse installed, and my project was now done.
It installs in less than 2 minutes. Just unplug the old switch and plug in the new one.
It was a breeze to Exactly what I was looking for.
We had searched locally for quite some time in order to find this replacement part. I needed a new switch for my MG 30DFX. In its place, this is a perfect replacement.
It was an exact match for the one I had broken, swapped the wires, pushed it into place, and the amp fired right I love it!.
This is a great.