Acoustic Guitar Fret Wire Set 20pcs Copper 2.0mm Width

For the price paid, these frets are decent. However, the crown height is very small and the description doesn't provide measurements other than the length of the frets. According to the measurements, the overall fret height is as follows The number 1145). The height of the crown is A mere 0. 87mm It was 0345). Huang Tang is five feet six inches high. This is a score of 0. 04mm It is "080"). The crown has a width of This means that the thickness is 0 mm The length of a tang is The number 0155). The barb will be as wide as This is a score of 0. 04mm This is 0415). In the pre- With a crown height of zero, the radius is approximately 11" and the height is about 1"

A mere 0. 87mm "), it's already below the height that many would consider too low for a fret level, much less a refret level. Therefore, unless you're going to match an existing fret in a case, or using it on an old "fretless wonder", these are too short. *The only other obvious issue is that the fret tang is nipped down quite a bit It may have been done so bindings of any size could be accommodated. When you refret your first guitar, especially a cheap one, you will want a short fret. These will do the trick. I would choose an alternative if the first option did not work.

Meredith SANDERSON

| Dec 21, 2020

Just be careful when pressing, because they tend to crack when heated up. There was only one issue Two of the 20 frets seem to have come from different lots. The fret from the extrusion had the markings on the side of the fret which were different, but there was no change in profile or fit.

Graham Woodard

| Mar 20, 2021

As a result of watching several videos on how to do the job himself and saving $250, I decided to change the frets myself. It was a great pleasure to obtain these frets and they Cut to multiple lengths and slightly precurved to fit the neck radius, they were cut to a variety of lengths and shapes. There were some edges that needed to be cut, filed, and sanded after the frets were installed. I recommend this product despite the fact that these frets were not as large as the ones that came with the guitar. They fit the neck grooves fine but don't have as much jumbo angularity as the original frets.

Atlas Goldstein

| Feb 15, 2021

It has taken me a couple of years now to install these on the guitar I have been working on for several years I was very pleased with the results. It's great to be here. I did not have to trim the fret wire, but I did have to file off the ends of the ruffs (very easy).

Leia Hood

| Jul 19, 2021

I used these on one of my acoustic guitars and they were great. My favorite part about the guitar is the way the frets are snipped so that the binding on the fretboard remains intact.

Carmen Moss

| Nov 15, 2020

While they don't look copper nearly as much as they have no yellowish or reddish glow at all, they are fine for acoustics - I purchased them for a 12 string guitar but they meet all the requirements, so I kept.

Vienna Lindsay

| Feb 27, 2021

There is a little filing to be done. The pieces that are cut up appeal to me. Fret jobs are completed faster with it. The majority of guitars have 21 frets, but you usually do not have to play all 21 at the same time.

Alexandria Sosa

| Oct 05, 2020

I needed one, however the price for a full set was great for a full This procedure was completed without much trouble for me
My friend's daughter was sitting on his school-issued guitar and he didn't have the funds to replace it or repair.

Messiah Robinson

| Mar 22, 2021