DASBET 6pc Front End Service Tool Kit Ball Joint Separator Pitman Arm Tie Rod Puller

I'm fortunate in that I have a reliable grinder. The hang-on-the-bar end tabs were far too small to fit. I couldn't even get them to mount because I couldn't get them out of the way. So I tweaked them a little and ground down a few of the nubs, and there you have it. br>br>If you know how to use a grinder or a cutter wheel, you can use this set on almost any rig. br>br>Best regards:.

Marisol Blair

| Oct 08, 2021

Metal made in China at a low cost. During the initial use, two threaded pieces bent.

Karson Jennings

| Dec 15, 2021

This is a great tool to have in your shop!.

Gia Mendez

| Jul 09, 2021

Well-made tools with a case; I haven't used them yet but am looking forward to doing so!.

Jovanni Collins

| Apr 08, 2021

The material was a poor choice. I was using one of the pullers when the arm snapped off the puller in one turn, and the pitman arm pulled wouldn't fit. I'd give it a negative rating if I had the option.

Harry Eaton

| Jul 17, 2021

Get a good amount of tension on the joint, then use your hammer to pop the end of the puller screw. Remember to lubricate the threads as well.

Kasen Morris

| Jun 03, 2021