Titan Attachments Dock Board 60" x 48" 290 lb.

As far as I can tell, this works fine. It is heavy as hell (all steel), so you will need a forklift to move * According to the U-shaped chart, there are also two U-shaped tracks A flat floor is impossible since the plate has channels welded to the bottom and unless your truck is considerably higher than your dock it won't sit flat. Rolling over it will cause it to kick up and slam back down, causing a very loud noise. A shim was attached to the bottom edge of the ramp to prevent this, but now there is a one inch step at the bottom of the ramp The forklift is okay, but the pallet jack is bad. Because, in an injury investigation, an investigator will look for a qualified mechanical engineer ("Mr. Supervisor, are you a Are you sure? I thought "") but it wasn't usable in that state.

Elle Jarvis

| Sep 10, 2020

You should beware! There is no way this dock plate works as it At the end, there ought to be a bend so it sits flush with A 1 can be found here. There should be a 5" gap between the plate and the floor. Neither a floor jack nor a forklift can be used. It is worthless. will now have to cut the medal, bend the last 4" of the plate, and re-attach the medal to the plate The plate needs to be welded before it can be used. Overall, the material appears to be of good quality, but it isn't of much use. I am disappointed.

Bruce GOUGH

| Apr 27, 2021

Stainless steel dock plate of high quality.

Norah Cruz

| Apr 27, 2021

Our needs have been met.

Ezra Pham

| May 19, 2021

Does what it's supposed to.

Bennett Williams

| Apr 14, 2021