Heat Shrink Butt Connectors, 50Pcs 14-12 AWG Black Insulated Waterproof Electrical Wire Connectors Automotive Marine Grade Wire Crimp Terminals Butt Splices, Ideal for Boat, Truck, Stereo - Black
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
It is also possible to work with solid wires!
The only other thing you need to do is crimp the ends once if your crimpers are decent. In the case that the wire pulls out when you tug on it, you will either need to adjust your crimpers or replace them. If you are using insulated connectors, make sure you are using crimpers.
If you're going to use a crimper, choose a professional one. Any top-brand crimper will do the trick.
Selected User Reviews For Heat Shrink Butt Connectors, 50Pcs 14-12 AWG Black Insulated Waterproof Electrical Wire Connectors Automotive Marine Grade Wire Crimp Terminals Butt Splices, Ideal for Boat, Truck, Stereo - Black
It was very inexpensive
But the connector doesn't have a stop for the wire in the center like other manufacturers do. In most cases, a red connector is a 18-pin There are 16 of them with a 22 gauge The wires are 22 so you have to crimp them each year on smaller wires. * They have a nice soft heat shrink material that did not puncture while crimping and shrank All in all, they don't work the best, but they do the job.
I needed them for the wiring of some outdoor lamps. When you pull both ends of the cables, and they seal well, they don't snap out. If you plan to heat the metal part, crimp the part first (as instructed).
Crimping devices that engage the connectors do not work with regular ratcheting crimping tools. There must be a problem with the tube thickness. The dimple crimpers I found were too cheap to work, so I used these instead. Dimple crimpers are problem since you run the risk of piercing the heat shrink, taking away the purpose of those.
They do have a wire stop in the middle of the connector, so it is actually much better than what other viewers reported. I was able to resurrect an ancient metal detector by soldering a connection on the circuit board we could not solder.
The value of buying in bulk at the wedding can't be beat though you'll find that buying a pack of 10 at the auto parts store will cost you the same.
Crimping the wire was done with a thin metal and copper. Since the wiring is so thin, I didn't want to pull too hard on the wire to look at it because I was afraid I would pull them apart. Usually butt connectors can withstand a little tension, but these can't. However, they cannot be called a good company.
I have found these to be very effective so far. I have been extremely impressed with the level of communication the seller/manufacturer has On Amazon, this book is among the best. I appreciate your kind words,.
There is a good shrink ratio with the heat shrink. It is thick and durable. It is a good.