CR-Scan 01 Creality 3D Scanner Upgraded Combo, Quick Scan, Automatic Identification Repair, Handheld/Turntable Modes, 0.1mm Accuracy

As a result, I thought that I would be able to capture high-resolution images of shapes using this device. This is not true in its entirety. A fake piece of software has been released. It is expensive to connect the cable because the connectors constantly detach. Once every two scans, the machine can't maintain a connection. There are many areas of scan quality that need improvement. In most cases, blob-like shapes emerge. Don't buy this if you don't want to end up disappointed! For this to be returned to China, it will cost you $75 dollars. Neither Amazon nor eBay are involved. It was a complete waste of time and money for me! I would not recommend purchasing.

Yareli House

| Jan 12, 2021

Hardware and software are both decently made, but the software is nothing short of laughable. As in the case of the quick startup guide, which consists mainly of plugging it in, there is no documentation. When I contacted Creality, they said that there was nothing more than that. This software does not make use of your GPU, so if you don't have a pretty hefty rig, you're in trouble. While this thing the floored my Ryzen 5700x I had a RTX Titan that had been dormant the entire time. If there are multiple scans with overlaps, you can't align them if you do multiple scans. This is the worst part of the situation because there is no way it could have happened. There is an accuracy of 1mm. There are a number of POPs offered by Revopoint. The new method has a greater accuracy of 3mm. Consider getting a Revopoint POP instead, or be prepared to spend more on something much more expensive. This isn't worth the time you'll spend on it.

Lila Beard

| Feb 25, 2021

Do not waste your money on it. Over the past couple months, I have read and watched videos on this scanner. I found the build quality to be good and it It was possible to perform a very good turntable scan followed by a well-done As soon as the second day had passed it was no longer working. I made sure the room was well lit and that items were not slick. There was a problem with doubled surfaces in the scans. In regard to the fox statue, it has two noses, and I tried to get some assistance from Creality, but I did not hear from them As a result, I will send this scanner back to the vendor, and I will buy a more expensive model that works or at least has.

Hamza Fritz

| Feb 12, 2021

took a 3D picture of myself and I think it turned out pretty well.

Millie Keller

| Dec 27, 2020