Firestik SS-3H Heavy Duty Stainless Steel Antenna Spring
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
When traveling at 60 mph, having a spring attached to the antenna helps to counteract the wind effect on the antenna. It is not required, but if your antenna is a 102-inch whip, it relieves the pressure on the antenna base, which is attached to the body of your car or truck.
It's a very stiff spring, and it's not sloppy in the least. In your pickup's stake hole, the 4' antenna should suffice.
Because the Firestik II is 3/8, this is a 3/8 thread.
Selected User Reviews For Firestik SS-3H Heavy Duty Stainless Steel Antenna Spring
This does not appear to be a genuine Firestik spring, despite the fact that it is advertised as such. When it arrived in a plastic bag instead of the original packaging, I suspected as much, so I ordered another from an authorized seller outside of Amazon. The complaints about rust and spring strength are most likely due to the fact that this is not a genuine Firestik spring. br>br>On both ends of the springs, you can see the difference in finish color and thread. In all of my photos, the genuine Firestik spring is on the left, while the knockoff ordered here is on the right.
If you're going to have an antenna sticking above your roof line where trees, garages, and other obstacles might cause it to bend, this is a must-have. At highway speeds, it also relieves strain on the antenna. It will, of course, add a couple of inches to its height. There isn't much to dislike or like about it; it's just a metal spring that does its job admirably. The only reason for a one-star rating is that it began to develop a strange coating the day after I installed it, which resembled the salt that accumulates on cars during the winter. However, it has had no effect on performance. Please press the helpful button; it would mean a lot to me if this was of assistance. Thanks!.
If you're anything like me, you've. Exceptional! This turned out to be a lot more meaty than I expected. It was a perfect match. If you're like me and need to remove your antenna to get into your garage, cut the tip of a latex glove to keep water and debris out of the top connector hole when you're driving around.
My firestik quick disconnect and stud are not corroded in the same way. I'm curious if the spring steel used is different. I'll take a picture if I remember to do so.
A buyer's honest opinion. So, I purchased these with the idea that they would be a great addition to my master plan. They fulfilled all of my expectations, but not all of my requirements. To be sure, in the ideal situation, they perform admirably. However, I am far from the ideal setting, but I am well aware of the capabilities of these individuals. Here's how I felt about the springs in general. The springs claim to be able to support antennas up to 5 feet in length. It's difficult for me to believe that. Yes, they function, but after about 3000 miles, the springs began to show signs of wear. It's not the end of the world; simply rotate the globe and call it a day. That works, but you have to keep turning to compensate for the antenna's lean. The second issue arises as a result of the first. You won't be able to get a good grip on these. The cap and spring ends aren't welded together. It's not the end of the world because you can still tighten them to a reasonable degree. To remove them, you'll need an extra pair of hands and a pair of plyers with a large mouth to hold the 1/8in thick cap end. This next part, I'm not sure if it's due to the antenna or my setup. I'm aware that my antennas are a little closer together than they should be. However, tuning and obtaining the correct SWR is not impossible with the spring and 5ft antennas. Mine is just on the other side of the clock at 1: 1 on the first channel and 1 on the second channel Channel 40, at 8 p. m. It takes about 1 minute to run channel 19 properly. These readings were taken after I had removed the springs, so keep that in mind. I was reading in the 2nd with them on. 5 range. When transmitting, large or small antennas will cause the radio unit to overheat. Now, I'm sure these would have worked with smaller antennas, but I'm still concerned that the wear from leaning against the wind will eat these springs. br>br>Overall, I had a bad experience with these springs. For its overall appearance, I give it a star. Based on my experience and use of the product, I have given it a two-star rating.
This spring is holding a 4' fire stick for me, and it's doing a great job! It maintains the antenna's upright position while traveling at highway speeds and bends when necessary. I've driven into my garage many times without remembering to take down the antenna, and it always bends without causing any damage to the antenna. If something hits the antenna and flings it back, it quickly returns to its original position without spinning too much, protecting your car from being hit. My only gripe with this spring is that after a while, it will begin to curve backwards as you drive down the highway. My antenna only tilts a few degrees, but it's noticeable, so I simply flip the spring around every few months and it starts to bend back in the opposite direction.
For a fiberglass stick, this is a must-have accessory. It's been a few days since I've used it, and it's already proven to be very useful. Because my 4ft antenna is all the way up my bed, I was concerned that using the wrong spring would cause it to wack my truck in the wind. This spring will keep it steady in high winds, but it will bend easily to save your antenna if it hits a branch. This is required if your antenna is made of fiberglass.
A HEAVY DUTY SPRING IS NOT INCLUDED! I should've paid attention to what the other reviewers were saying. This isn't a heavy-duty spring by any stretch of the imagination. It now has a 3-foot Firestik antenna attached to it. With regular vehicle movement, this spring flexes and begins flapping back and forth. Even something as simple as driving up the driveway's incline causes it to flail. This isn't even close to being a medium-duty spring, in my opinion. This isn't the spring for you if you want a stiff spring. I put it off and now I'm stuck with it because I missed my return date. I'm on the lookout for a new heavy-duty spring right now.
Related Products For Firestik SS-3H Heavy Duty Stainless Steel Antenna Spring
