Shankly Flywheel Puller (46 Piece), Complete Crankshaft Pulley Puller, Steering Wheel Puller
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
It is not possible to answer your question properly without more information.
the kit to remove the fly wheel from a 25hp Johnson engine. The washers that come in the kit are very soft, so I recommend using some grade 8 hex head screws instead of the ones that come in the kit.
There are certain jobs each will be assigned to where one would work and the other would not
Whether or not this tool will work with your particular application is unclear to me. Flywheels should have drilled and threaded holes no larger than 3 mm if there are three or more holes on the flywheel. With the spacing of 3-4 inches apart, I'd be sure that it would work
Selected User Reviews For Shankly Flywheel Puller (46 Piece), Complete Crankshaft Pulley Puller, Steering Wheel Puller
The first time I used it, the threads fell out of the center piece. It took me a long time to get some before the bolt went all the way through. The item is made from aluminum cast. I bought Chinese junk for a cheap price.
The materials may work well in automotive applications, but they do not hold up well in powersports where everything needs to be fitted on tightly.
Especially when you consider As for the box, it's very nice, and the set itself is decently made. Especially when you consider It would have been nice to see more bolt options included, and some of the ones that are there only have two bolts rather than There are some applications where this does not matter, but there are others where it does. There are a lot of sets that do this, but Shankley is one of them. Although the price would have increased slightly, I would've liked to see there were a few more bolts. It is still not too shabby.
Our research facility has many shaft pullers. In order to do this, I had to pull the It turned out that this box had one screw size that fit our wheel so we didn't even have to buy a screw outside As is, it does a very good job of completing That did a nice job of pulling it off.
This item appears when you search for motorcycle flywheel puller, however it does not come with 6mm bolts these bolts are normal for There is no mention of the sizes of bolts used by Yamaha, Honda, Suzuki, Kawasaki, etc. In this kit, more bolt sizes are needed. However, you will most likely have to buy your own bolts, since the puller does not come with them.
This part was purchased to replace the crank pulley on a Nissan 3 - for removing the crank pulley. The kit is organized well and fits into a 3L engine. While the kit has a good selection, it does not come with the 6 X 75MM bolts I need for this project. It will bend under heavy torque as far as the flange (slotted piece) is concerned. If the lip is outward, it can be difficult to chew.
In addition to pulling a rear wheel from the 1964 murray lawn tractor, I used it by pulling a whole lawn In the end, the tool bent but managed to remove the wheel! The way to fix the problem is to use a WD-40, an air hammer, and lots of brute force. Despite my initial skepticism, I am very satisfied with this puller.
There was another set I had to use in addition to this one, and I found a third bolt I had to find, for my application they only included two of the three parts in that size. It is a bit strange that they make sets that require 3 bolts for most applications, but only include 2 of many of these.