kweiny Engine Air Valve Holder and Cylinder Leakage Testing Assistant Tool Fit with M12 or M14 Thread
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
Trying it out on a 1966 283 Chevrolet engine, I found it to be very easy to operate and reliable, but you will need a small wrench to tighten the tool into the spark plug hole. For the unit, I ran about 40 pounds per square inch and left the air compressor on, depending on the needs.
It cannot be removed, according to me. My only question is how you tighten it once it has been placed into the hole very tightly. I have found that the fitting fits most spark plug holes that I have encountered. I found that the easiest way to do it is to bend your wrench in a small way to gain access to In practice, you do not have to tighten it a lot to keep the
The Buick 3 comes equipped with spark plugs as standard equipment. Installed in the spark plug position, this item is intended for installation near the spark plug.
Selected User Reviews For kweiny Engine Air Valve Holder and Cylinder Leakage Testing Assistant Tool Fit with M12 or M14 Thread
If that is correct, then yes.
S. air line fitting. It's just right. The tool should come with a variety of fittings so it can be used immediately.
I was very satisfied with the product. Only the fact that I had to use an adapter for my particular application kept it from a 5 star rating. It would have been nice if they had included that. It works well with the adapters that come with a pressure gauge. In the end, it was satisfactory.
It's a nice piece of artwork. When the valve is open, the seal is complete, and there are no leaks. Using the thread and oring without lubricating them is not recommended. Keep an extra pair of orings on hand in case of emergency.
It is just a few days since I got the air valve, so I haven't used it yet. As I am putting in the review, I am using the items. A smooth motion is utilized to open and close the valve. is made of brass and appears to be well made. In a few days, after I replace the valve seal on my classic Studebaker, I will update the review accordingly.
In a nutshell Among the pros There are two sizes of spark plug threads on the ball valve (on/off) lever. The cons are Male attachment that came with my air compressor had a different shape. The way it is sold is that it has it installed by default, and removing and replacing it is very difficult unless you have a vice.
All in all I plan to run a small motor from compressed air using it, and I think it's quite useful. I appreciate your help.
I was surprised at what this product did. This product is of very high quality, and it is very reliable.
I love how it works. The valve stem seals could be replaced in a snap.