LIMICAR 53 LED Red RV Camper Trailer Stop Turn Brake Tail Lights White License Plate Light with Reflex Surface Mount White Base Red Cover Reflex Lens Rectangular (Left & Right)
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
There was no difference in the color of the wires in the lights I replaced. White is ground, according to my understanding.
Your tail/running lights should be hooked up to the B+W wire, while your brake lights should be hooked up to the W+R wire.
They (lens and base) have been screwed together with o-rings In between pieces, there should be a ring. They think they are submerged, but have never submerged
Older lights on my boat were screwed into the fiberglass with screws similar to those used for sheet metal. The following is a revision I just made This is the hardware I have been using.
Selected User Reviews For LIMICAR 53 LED Red RV Camper Trailer Stop Turn Brake Tail Lights White License Plate Light with Reflex Surface Mount White Base Red Cover Reflex Lens Rectangular (Left & Right)
My trailer's brake lights needed replacing, so I replaced them with these lights and they work Thank you very much for offering this light at such an affordable.
This was purchased to replace the old Command Electronics incandescent There were no need for new screw holes since the holes were perfect fit. There were a few differences in wire colors, but there was no problem figuring out which wire to attach to which. This light is much brighter than the original ones, so now I feel more secure when I pull my trailer!.
The installer is easy to use. The screw holes for this light align with the existing ones. It will be necessary to use a test light since wiring is not included. If you are installing the license plate while the light is off, be sure to do it before the light turns on. It is a good replacement and there is no need for a load adapter.
need to confirm if your trailer wire colors match these and if not, find a diagram of your rig to compare. I think these are a little smaller than my factory lights, but they are I feel safer using this taillight than the old single bulb taillights.
On the camper, it looks great and works well. As I put them on an older (90's) camper, I was able to tighten the one with the license plate bracket down and then put the license plate back on but it stuck out on a 45 degree angle because when I tightened the bracket down. In order to fix it, I used a heat gun to get the brackets hot so that they could be bent It's a great set of products that looks good and works well.
It is too dark to be able to see anything or be safe with these lights. The unused set will be returned. They sapped my energy and I got screwed with them since I installed and removed them.
Although they can be seen in direct sunlight, they are bright.
The installation hardware was of high quality!.