JR Products 12245 Black Triple SPST On-Off Switch with Bezel
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
The switch is normal size, but you cannot tell that it is a quality one.
It's a JR 13085 brown switch that I replaced one of the switches with. There are two switch locations for one load.
You don't have to illuminate them in order to use them.
No, I wouldn't guess so. You can see it on marine
Selected User Reviews For JR Products 12245 Black Triple SPST On-Off Switch with Bezel
It's easy to do. Easy as pie. Because the middle switch needs a third attachment to connect the wires, I missed this important fact, which I realized after the fact. As I was replacing the switch, a light came on that could be turned on from either the bedroom or living room of our fifth wheel. The fact is, without that third place to connect the wire, it could only be turned on from the bedroom (which is where the switch is being installed)
But, most importantly, I am a mom of two with a husband who often works seven As far as handymen go, I'm not at all qualified The human being. Using parts from the old switch and this one, I was able to create a functional one that would keep that switch working from either location and fixed the broken switch next to it. These cone apart with just a flathead screwdriver and quickly reassemble. Therefore, if I can do it, anybody can do it. This product matches the original one that came with our RV exactly in terms of color, appearance, and size. You will be grateful to have a switch that even a stay at home mom can install and figure out how to use.
There is no problem with these switches. Usually a hole is needed to make them fit flush, but the trim rings hide Don't solder the switch terminal if you don't know what you're doing. The first switch I used melted, and I had to find another to replace it. It worked fine when it was attached to the terminal, but now, the switch needs to be connected to a different wire. What I had trouble with was removing it from the wire. There was too much heat involved in removing the original wire and soldering it in. This terminal is very close to the plastic rear side, so it warped when the heat was applied. The contact between the switch and this terminal then stopped My next purchase will be a new one and I'll plan the wiring better.
In the spring or summer of next year, I'll probably have a chance to work with these switches. It is likely that I will have to use an intermediate solenoid switch for anything pulling more amps than LED lamps if they are not compatible with DC current. My intent was to use them in my RV for selecting solar charge controls and for other electrical functions.
I use these to wire 12 V accessories in my camper and they work very well for that purpose, but be careful and don't try to solder the connections on them. You will melt your switch that way. Just use the push on connectors and your good to go.
Two switches are connected to my 12 volt system one is from my water pump, the other is for light control. I was able to install it without any problems, and I have an extra switch to use when I install my.
E. My reflection 311 for 2019 is just like an oe. As part of the upgrade, I installed three switches in the master bathroom so I can run the fan round lights and the motion lights.
I added a brown panel to match the existing switches in my 2014 Minnie Winnie, which makes the outfit look professionally done.
During the annual maintenance of our 2009 Itasca Navion iQ, we replaced 1 switch that was over the fridge. Similar in color and style to those found in this RV, this panel is an exact match. An example is shown in the picture. It would be great to find white labeling for this product, but it's not that big of a.