URBEST 300RPM 12V 0.6A High Torque Mini Electric DC Geared Motor High Torque Electric Micro Speed Reduction Geared Motor Eccentric Replacement Output Shaft
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
A 5/16" exposed end of the shaft was machined flat so a pulley or gear could be mounted there. I do not have a drawing. A total of 2" is the length of the shaft. There are five-eighths of a diameter to the motor. It is my hope that you will find this useful.
I don't think I remember, but stall is vs/dcr of the motor and is dependent on the voltage applied.
It took me a while to remove the motor and move the contacts 90 degrees so that the generator could be built. The tools you will need for this are a press drill, tap, and die.
A D-shaft with a diameter of 1.6 inches is used A pinhole does not exist in this shaped piece.
Selected User Reviews For URBEST 300RPM 12V 0.6A High Torque Mini Electric DC Geared Motor High Torque Electric Micro Speed Reduction Geared Motor Eccentric Replacement Output Shaft
Despite having a very small metric thread, this motor's outstanding torque characteristics make it one of the best motors for driving wheels in robotic projects, etc. The mounting holes on the front are M2 (2mm), which is not that difficult to find if you look around. To connect the motor, you will have to solder wires to the small plugs on the back. This is an excellent little motor and I intend to have six of them for.
My son reports that it has failed twice so far, so I don't know why it says 6000rpm in the title, as it's more likely around 300, but it works, has never failed me.
There are these. They are. This is incredible. Despite the immense torque, the engine is only able to deliver a marginal amount of Don't worry about servos for a while. Just grab some cheap 3mm hubs. The two motors I purchase are my second purchase of this type. The extra cost is well worth it.
If you like to experiment with motorized objects, this motor is a good pick for you.
Despite the great design of the gear motor, it does not have a high rotational speed. It seems the 300 rpm must apply to the motor speed since the output shaft in my gear motor turns at no more than 60 rpm when I go to the VA setting.
I broke about half of the pieces. In any case, if the post is pushed over even a bit, it'll break the gears and the device will no longer function.
As far as I can tell, things are going well. Thus far, it has not been a problem.
The only issue I had with it was that the shaft of the motor does not have a pinhole, so I had difficulty using it appropriately, however, the motor itself is rather decently powerful. There was only about a two pound load connected to the loader. This motor is still undergoing testing to find out how long it will last.