Stromberg Carlson LG-217884 Venture Landing Gear Motor and Switch For Landing Gear-1
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
I did when I was a kid
We would like you to follow our Check List before replacing any items. *br>If you hear a clicking sound from your motor, it could be the safety clutch to prevent the motor from being damaged. There is no gear box here. You should release the power switch when you hear clutch noise. If you fail to do this, you will damage the motor as well as other components of the system. Make sure that the bindings are correct It is important to clean your trailer's legs on a regular basis and check them for debris. It is possible for legs to bind if they are covered in sand or dirt. The landing gear legs should be cleaned as follows Extensions of landing legs should be made as far as possible, as well as the drop tube and inner ram tube being cleaned. Using a silicone spray lubricant, coat the exposed surface of the tubes. Adding silicone spray lubricant inside the handle alignment tube will make it easier to align. *Use SAE 30 oil to lubricate bushings in gear boxes and leg gear heads. Lubricate the gears at the landing leg gear heads on the gear box and in the gear box. It is not recommended to open the motor to lubricate it, as this will void the To check for leg damage, do the following In the case of damage to the legs, such as bending or denting, binding will occur.
Make sure the power is on to the You should check that the batteries and power supplies are at full capacity to prevent the motor from being damaged. Be sure to check the wiring connection at the Solution of baking soda and water should be used to clean terminals. Spread a thin layer of grease over the surface. Ensure the wiring harness fuse has not blown, and replace the blown fuse with an appropriate one. Keep the weight of the landing gear system below the maximum allowable. If you are changing tires, repairing axles, or servicing the trailer, be sure not to use the landing leg to lift the trailer (the trailer's weight is greater than the load.) Designed to stabilize a portion of the trailer's weight, the landing legs act as a stabilizing device. Install structural stands that support the front end of the trailer and are rated for the trailer's GVWR.
While I wouldn't spray water directly into the switch, the back of it was covered by a membrane that is nonconductive. It would be unwise for me to mount it an exposed location where the elements are constantly present. There is a lock on the lid of the box where my switches are mounted. Could you please let me know if
Although I am not certain that this will be an exact replacement, I am positive that it will work. As far as I remember, I replaced the jack motor in my 5thwheel camper in 1986 with this kit. In terms of their universality, they pretty much all apply. You will need to make sure the mounting plate diameter is the same and the spindle on the jack is able to rotate the shaft. This should be of some assistance.
Selected User Reviews For Stromberg Carlson LG-217884 Venture Landing Gear Motor and Switch For Landing Gear-1
According to the advertisement, the switch has been omitted. This product is poorly packaged, and looks like it has been Not a single instruction. The money was a waste.
I need some advice. There is no way to raise the trailer with this unit. A slip clutch with overload protection sounds like what it is. Would it be possible for anyone to advise me before I return this I have no problems using this unit without any.
There was a problem with it.
As soon as I received the order, the motor had severed the wires in half in the box. It appears that something had slammed or dropped the box, as it caused the wires to be severed.