Buyers Products 5543895 Tarp Gear Motor (Gear Motor,Tarp,12 Vdc,900 W,90:1,3 Yr)
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
The key has not been placed. A bolt hole and a screw hole
There is no design for continuous duty on this motor. In addition to its intermittent duty, it would also be used in emergency situations.
A linear actuator had to be installed since the bolt was not long enough, and it works flawlessly now
Selected User Reviews For Buyers Products 5543895 Tarp Gear Motor (Gear Motor,Tarp,12 Vdc,900 W,90:1,3 Yr)
Take note that this motor requires an 80 A circuit breaker with appropriate wiring and relays as it is 75 A. Take note that the motor is in good condition on the outside and appears well built. I believe it to be on the high power end of the tarp motor spectrum. As part of the kit, the motor comes with an instruction sheet that says to align the shaft of the gearbox with the template. Note Caution must be exercised As a part of the template, a reduced-sized clipart image was provided As is, the mounting hole pattern was printed at the wrong spacing on a copy that was not scaled. As a general rule, bolt patterns should be square with approximately 2-inch bolts. There is a gap of 1/16" on each side. I used template 1 for the template There is a nominal diameter of 7/8". If the motor comes with a reduced-size sheet of paper, it may be a good choice Be sure to measure the size of the photocopy. There seems to be a closer spacing of 2 in reality. The 2. 05 is smaller (52 mm) than the 1. The number 03 on this sheet appears to be incorrect. The vendor should include a warning that the pre-printed template is NOT to scale.
It is an AAA+ product, which I ordered the day after I ordered it.
The product has fast shipping according to what has been.
Great piece of software.