X AUTOHAUX 36" Car Universal Throttle Cable Braided Stainless Steel Accelerator Black

I built a new single-screw transmission to replace an old single-screw one while restoring my old Mopar truck The 4-barrel carb has been replaced by a 6-barrel carburetor This is a bolted barrel All things had to be replaced It takes a lot of parts to build this kind of bike - exhaust headers, intake manifold, carbs, etc. I found a simple throttle cable mount on Amazon for only $20, and only needed one I worked perfectly here, but it is a bit the entire cable in the car to ensure a good fit If the inner cable is attached to the outer housing, remove it then. (3) Wrap the area to be cut in masking tape and clearly mark the location SS braids only cut with a Dremmel cut - The wheel has come off. Make a clean cut with a razor blade on the Teflon core. Ensure that the throttle cable ends are mounted securely in the adjustable throttle cable end. To mount on carburetor, take piece and mount. The surface should not be too loose and should be snug A stable situation. Size of holder (make sure it can be inserted deeply into holder An important part of cutting is the test fitting. 1) Cut cable with shape wire cutters once you have determined the depth. Your cable may fray if it isn't pliable. When I tap gently on your shoulder, I find you - You need to weld the wire tip together to seal it. (3) When done correctly, you will get a factory result. Don't overdo it Fittings made from aluminum should be tightened.

Hanna Freeman

| Mar 27, 2021