Mxfans 308006 Blue Aluminum Alloy 380 Motor heatsink with Fan for RC Car Motor Heat Sink
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
This may be the case, as long as you have a motor that is 380mm in diameter.
The unit plugs into the open slot on the cars speed control where the steering servo and motor are located
You can't possibly turn off the voltage at that level. That will burn the fan faster than you can say, "oops, too much power.".
I've tested it on my 1/16 Erevo and it works well. Hopefully it will work as expected.
Selected User Reviews For Mxfans 308006 Blue Aluminum Alloy 380 Motor heatsink with Fan for RC Car Motor Heat Sink
There is a nice and quiet fan which doesn't touch the inside of the shell when it runs. My rating was 4/5 because of the connector that does not fit into the receiver of my merv, so I had to cut it off and solder on a connector from an old steering servo, but it works great and keeps the motor from going into thermal protection. I've updated to Take it off before you jump off big jumps, since it's the highest point under the shell. It didn't work out for me, so I bought.
Among all the features I liked, the price is the best. Aside from the fan, the heatsink seems well made as well. Unfortunately, the combined sizes of them cannot fit on the 1/16th inch frame The Revo. There is little to no movement when the heatsink is attached to the motor body. Due to the receiver box being on one side and the esc being on the other, the fan will not fit. If you can figure out a way to attach the fan to the top of the heat sink, you should be able to do it. In either case, the Traxxas heatsink is far less expensive and features a fan as well.
In addition, I am looking forward to finding out if it will hold up!.
This seems very strange since the fan would no longer spin if tilted more than 45 degrees The fan has to be mounted upside down so it is blowing downward. Using cable ties to stop the fan and heatsink from spinning around the motor has been the only thing that has worked. The program works, but I will try doing something different the.
I found it to be very tight fitting and the power cable is barely long enough to reach it, but it fits and works. The motor on my Slash only hovered a few degrees above ambient when I ran two 2S lipos through it.
The wires are routed after the clips are connected, and the plug itself is plugged in after that. It keeps my VXL cooler and it looks like it does its job. It is quite disappointing that the fan does not have the power I.
It was great to receive the merchandise for the price I paid. I had to modify the item to fit my motor but otherwise it was perfect. It works perfectly and looks good too.
It snaps right into place and seems to work very well, this is a product I would buy.