POWERTEC 70261 4-Inch Double Wire Hose Clamp | 10-Pack
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
When you are familiar with a 4 inch dust vacuum hose, these will fit on it as well as any standard 4 inch vacuum pipe. The screw is about halfway into the hole which makes them tight on pipes as small as 3 3/4 inches.
The screw is a 10mm hex with a #2 Phillips head
No matter which way they turn, they aren't left or right It is easy to access the clamp if it is oriented in the easiest way. Spirals are on- A clamp must "cross over" a spiraling hose wire in order to clamp a wound flex hose, and this is relatively simple to accomplish. When you zoom in on the screenshot in the listing, you can see that there are no limits to the clamping
Selected User Reviews For POWERTEC 70261 4-Inch Double Wire Hose Clamp | 10-Pack
The rest of the packs are good, so I bought a few more. Recently I bought a new bandsaw, when I went to connect the dust collection hose, I realized I wasn't able to use my As a result, I ordered some more because I have been using them all. So I didn't run out of juice again, I got an extra pack. It is nice to have a clamp that is so heavy duty. In addition, I like how they come with 2 wires so you can access them from either side of the hose wire. Work as they should, I am very happy and I would recommend them.
The price is cheap and the price is A washer is used as a reference against which the threaded rod is adjusted. Of the three times, one is more likely to occur? In this case, the washer will run up the rod and render the clamp ineffective. I used small nuts as filler- The problem was fixed by changing the nuts (which were smaller than the rod) and placing washers in the right places. However, I dislike the need to make modifications in order I expect to spend a little more in the future on real hose clamps.
The application is still working, but it is not as refined as expected. The ones with thumb screws are also better for me.
There are two great ways to connect 4 inch sawdust collector pipe. Put a plastic connector pipe at the end of the connector pipe and put a wire clamp on the pipe. This provides a dust-free The metal coffee can (4 inches in diameter) can also be used to slide inside the pipe with the connectors attached. A good one can be found if you can.
In addition to saving you a lot of frustration that the standard strap bands cause, these also provide you with better alignment. I haven't had a leak since the seal is great!.
It is easy to install. INVESTIGATION IS SIMPLE EVEN IN TIGHT SPOT.
Very sturdy and works well.
Shipping was fast, the price was good, and the value was great.