Yonico Router Bits Louver Slat 1-1/4-Inch 1/2-Inch Shank 18153
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
In fact, you can use this to create louvers that are 3/8" thick and still have rounded edges. Yet, that is just the bare
Selected User Reviews For Yonico Router Bits Louver Slat 1-1/4-Inch 1/2-Inch Shank 18153
A louvre bit is employed for shutters or blinds often, so it gets a lot of use. The louvres on even medium-size windows need to be a lot bigger. A pass for each louvre is multiplied by four. In my project, I needed 99 of the louvres to be 20" (51 cm) each, so I used 24" stock (2 1/2 x 3/4 stock Select Pine) cut in half lengthwise on a table saw (yes, I repeated this process twice). I would like to emphasize the following points. In use, add about 2" (2" if you use your finish length. The importance of support during cutting cannot be overstated. To make one of the pieces, I used two of the same-sized pieces As a guide, use a stock of a given thickness Glued to fence to hold stock down vertically, second layer on first, offset lower to hold stock laterally on Each pass changes the edge of the board), similar to a feather board. The louvres require 4 passes for each visit The edges may be one or both. In my estimation, a routing of 99 x 2 feet (61cm) x 4 passes equates to nearly 800 feet of distance. There is no doubt that this is a very good and up to the task bit. Taking proper care of your equipment is essential. During the middle of the game, I removed and resharpened the diamond cards (600 and 1200). However, if the finish starts to look bad, stop, tighten your bit chuck, and start over. There is no time to waste. Although I used a new Triton router, I still had to tighten about six or eight The cap on mine completely came off while using it. Due to my lack of attention, I failed to check. Make sure the screws are tight. Despite being a specialty bit, it does well, but it gets a lot of use. This is a highly recommended book.
I have run two hundred board feet through this bit so far and it has performed perfectly. Time saver of a huge magnitude.
Maple cutter that cuts excellently on its first pass.
Product of high quality.
The product is nice and well made with a good finish.
This is a good product.
Shipping was quick and the product was of excellent quality.