Irwin Tools 49614 Brad Point Drill Bit, 1/4"
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
Irwin is delighted that you chose us. A short twist length is used in this bit to provide a high quality service. This product has a diameter of 11/16" and an overall length of This is "19/32".
Using this drill bit, you can drill a hole of 5/16 inches.
A bit is 4 5/8" in length and 2" in cutting face, with an overall length of 4 5/8".
An overall length of 4 inches is given by the IRWIN 49615 This is "19/32".
Selected User Reviews For Irwin Tools 49614 Brad Point Drill Bit, 1/4"
What it does is what it should Irwin is a quality brand, so you can trust it. With free shipping, the price was slightly above average, so I paid a little more to do what I like and not go As a result, I used it to drill holes in wood for making pin and other punch holders, and the bottom surface of the hole was flat. You could try out very low speeds at first until you break the surface, then medium speeds for really nice holes in the surface.
The hole in the aluminum panel was only 1/16" thick, so I knew I needed to use a 7/16" bit. There was something missing in this bit! I didn't only fail to cut through my panel, but that pointed thingy on the tip enlarged the pilot hole unevenly, causing the bit to wander, making a mess of my project.
A brad point drill bit is being used A wood drilling machine is dedicated only to Don't try to drill aluminum, stone or any other materials that are harder.
There are many good shop tools made by Irwin. Having an extra bit is what prompted me to purchase this item. When I work on furniture, I use this size when drilling mortises.
To drill through red oak I had to use a great deal of pressure with a 3/8th bit. flutes on the side of the drill are extremely sharp, but the leading edge is extremely It is very difficult to exit through the hole because it has been splintered so The design is incredibly bad but the product is well made. This is not something I would recommend Approximately 100 more holes need to be drilled and I am hoping it holds. I can only comment on one good thing about it, which is that when it goes in, it doesn't splinter the face side, but it blows out when it comes My recommendation would be to drill a hole of 1/8th inch.
As an Irwin customer, I had no concern about the quality of the drills since they were reasonably priced. To be accurate, I had to apply a great deal of pressure to get the 1/2" drill to cut the cedar and ultimately I resorted to using an old Craftsman spade type drill, which worked flawlessly. When I bought the drills from Irwin, I made a very poor decision. In fact, it occurred to me after the first few seconds of using the Irwin drill that it was running in reverse. I didn't think it was.
Brad points out an interesting point there. This is a good product. Is sheerness a term I haven't heard of before?.
Drill bit of good quality.