FSJEE 2Pin 8mm LED Strip Connector Kit Include L Shape 2 Pin Right Angle Corner Connector, T Shape Connector, Solderless Gapless Connector, Strip to Strip Jumper Wires for 2Pin 8mm 3528/2835 LED Strip

This is a nightmare. The connections are too wide for the pads on the LED Light Strip they're supposed to go on. They don't stay put once they're in place, and any movement will cause the connection to be broken. Solder wires to make connections instead if you have the ability to do so - Purchase something else if you are unable to do so.

Misael Fischer

| Aug 28, 2021

Fortunately, I only needed a few clips, but I discovered that some of them required squeezing to work. I was able to use enough of them, and I believe the concept was sound, though it could use some improvement. I used them with Govee white led strips and they worked great, with the exception of a few strips that didn't keep connectors tight enough to work.

Josue Farmer

| Mar 14, 2021

I haven't yet tried them out in the open. I used cable staples to back up the adhesion, even though it appeared to be fine. The parts I used were not difficult, but my sausage fingers made it a little more difficult for me to work with these small parts. In general, a fantastic collection.

Augustine Horne

| Dec 02, 2021

Even with pliers, the strip wires would not stay shut when trying to connect to another connector. It will not close due to the wire thickness. Unusable in the most basic sense.

Julien Garner

| Jun 03, 2021

with led strips with a weather-resistant coating The connectors did not provide good consistent contact after the coating was stripped off, so I discarded them all.

Keanu Russo

| Dec 15, 2021

The snaps for the connections are a little finicky to work with. There is no soldering, and I'm not sure if they are waterproof, but I doubt it.

Opal Shelton

| Sep 06, 2021

Many struggled to keep their doors shut, and those that did had to work in a crowded environment. It didn't work after I double-checked everything.

Santino Anderson

| Jun 30, 2021

There were only two "T" pieces, and I could only use one for both positive and negative sides, so I had to find a package of just t's to get what I needed.

Nola Watkins

| Jun 16, 2021