Rubber Leg Tips Black, 1" 4-count
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
There is approximately a one-inch gap between each opening.
That isn't the case, according to me This is a fairly inflexible rod that is slightly under an inch in diameter (for a tight fit on 1 inch rods). Also, they are smelling strongly industrial, which does not seem to go away over
No slip, no fall! You don't want to leave a scuff mark on the floor, but the floor should be soft enough to grip. These went on the legs of a chair with metal legs but a plastic base that was quite hard. On other chairs, I've observed that the plastic wore away quickly, exposing the metal to scratch the floor as a result. My favorite item is these outdoor folding chairs. I put them on four of them.
Using them for square legs would be a mistake. This would not be a good match.
Selected User Reviews For Rubber Leg Tips Black, 1" 4-count
The product is good, and the tip is useful. You might consider placing a 1" washer inside the tip if you are installing the tip on a steel tube leg. In this way, you don't have to worry about the tube end cutting into the tip because the washer will carry the load instead. You should use a washer that is the correct size for the diameter of the leg. The process of fitting.
Originally, I purchased this set of leg tips to replace the ones on my kitchen step ladder that had worn through completely. In the beginning, I tried to remove the old ones, but when I tried, they were glued on and would not come off, regardless of how much twisting and pulling I did. My legs have a tendency to stretch, so I noticed that. In my opinion, these should be placed on top of all The tire was difficult to push, and required the use of a letter opener and a hammer to complete Thanks for making this, it's very well made. I am very satisfied with this.
The replacement rubber shoe was used on the bottom of a fishing pole to replace the one that was lost. The shaft of the rod was a little too big to stay on tight, but 5 wraps of electrical tape around the shaft filled in the gap, making it work.
They worked well. Regardless of whether they are better or worse than the original rubber leg covers, they fit well.
It is a nice product, but it is There have been a few times I have contacted them, but I have not been able to get anyone to exchange them with me!.
This is better than the originals I had on my bar stools. No damage is done to the floor tiles, and the stool stays where it's put, so there is no risk of it moving when you.
I found just what I was looking for here. The new feet that I needed were exactly the match I needed for my ladder.
Thanks for being so fast about delivering the chair feet for my husband. It was important that his chair could help him get up and not slide when he was getting up from it. Now it is safe for him as well as the floor.