LONSEL 1'' Scope Rings, 2Pcs High Profile & 2Pcs Medium Profile 1 Inch Scope Mount Rings for Picatinny Rail - Pack of 4
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
LONSEL 1" Scope Rings fit standard picatinny rails just fine. Thanks.
Yes, they should work; just make sure the top ring screws aren't overtightened. 30 millimeters = one millimeter 181 inches in length
The biggest question is whether you have the right for your scope if it has a standard rail. Can't complain about the quality, it tightened up nicely and seemed as sturdy as you'd expect a simple scope mount to be.
No, you'll require m-. Look for scope mounts or adapter plates that are specific to your scope.
Selected User Reviews For LONSEL 1'' Scope Rings, 2Pcs High Profile & 2Pcs Medium Profile 1 Inch Scope Mount Rings for Picatinny Rail - Pack of 4
They're decent; the screws are thicker than brand W's, and the aluminum is fairly thick, so they should hold up in most situations. If you end up bending anything tightening it's entirely your fault; these screws don't need to be wrenched down as tight; instead, a small dab of locktight purple or orange will allow you to remove them and torque them to the proper torque for a small screw, such as 15-mm. 20 pound girth. Overtorquing or hammering down will only remove any extra accuracy you may have had, as well as warp or strip the mounts and screws.
Ring screws in the same ring that are mismatched and are either too short or too long. Worst of all, one set of rings (the short ones) will not fit into a weaver base rail due to the bolt being too thick. What is the situation with this firm? No matter what the price, I would not recommend purchasing.
These are well-made and cost effectively priced. Just keep in mind that the larger set only has a one-inch gap between the scope's bottom and the rail. It's possible that some applications won't give you enough room or allow you to see the open sights.
These should not be used with rifles that have a lot of recoil. That's exactly what I was hoping for. For one of the old 22s, I bought these. It has a good chance of succeeding. I used the other set on a 308 until my vortex scope rings arrived, which came in a pack of four. I tightened the bolts and headed to the range. About 20 rounds in, the screws began to back out. Again, it's not a huge deal; it's exactly what I expected. I simply would not recommend it for use with center-fire rifles.
get 'em.
These were the perfect fit for my 50mm scope. The objective's lens cap will clear the rail with enough room. They are appealing to me.
It was difficult to secure the scope to the base, and as I tightened the screws, it bent.
Although I'm not sure if it's of high quality, it does the job. It's small and light, but it's strong enough to hold the scope. Because it's 2021, I haven't been able to test it with ammo.