CPWR-WS-240-33 Water Level Gauge
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
If this is the case, then I cannot see how the reading is accurate. Sensors and gages like these are great, but they work on resistance from the sensors. In the event that you introduce another load, the balance will be changed. If it is placed on both gauges, it will throw off the readings.
This item is installed in my van and it is on all the time. Although it draws so little power that you could probably put a switch on it, I don't care about it.
Connecting the wires is as simple as splicing them
Selected User Reviews For CPWR-WS-240-33 Water Level Gauge
In my small RV, I have a fresh water tank without a gauge that I need to measure. It was important to me to know how much water is left in the tank, so I decided to find a simple way to measure the amount. For a while, I had to go outside to check the water level by opening part of the hatch. It was very easy to install the gauge. The first thing you have to do is determine where to place the equipment. You have to make sure you have enough clearance behind the gauge since it extends about 1 1/2 inches behind the surface. You must also keep in mind that it requires both power (12 volts) and a Make sure you drill the hole to the exact diameter because the gauge has a very small bezel (so there is The unit should be connected both to the power source and to In order to make the gauge more legible, it can be backlit. Just to be sure, before I installed the gauge, I tested to make sure the sending unit and gauge were working. There is only one downside to the gauge, which is that it lacks linearity, which means that there are Therefore, full will be displayed until the sender unit gets to 3/4, then 3/4 will be displayed on the gauge. Honestly, it wasn't a deal breaker for me, but it is important to understand that the gauge might not be 100% accurate.
Installs and wires up in a matter of minutes. Water flow updates will be made when the water flows.
Wiring a test circuit on a 11 was simple. Another micro switch level sensor from Kurs is the 5" micro switch level sensor.
The level sensor was purchased from the same manufacturer along with the tank level transmitter. The construction quality of the building The easy way- The lighted dial is easy to read An explanation of the wiring is clear and understandable.
The magnetic sending unit works well with this product. In real life, 1/2 really means half. There is no difference in accuracy based on the level. A very difficult task to find an accurate gauge. My VDO fuel gauge will also be replaced with a new one.
I like the design of this item, it looks good, and it's a great.
I need to have one of the clocks changed as soon as possible, since one of them has gone wrong.
It's perfect. Thanks!.