1UP USA Rack Stash, Hitch Mounted Bike Rack Storage, Ski and Cargo Garage Organizer, Wall Mounted
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
To attach the piece of wood to the interior studs of your wall, you need to buy a good piece of wood. Ensure it is long enough to reach 3 studs, and then mount the device in the middle stud using the 3 3/4 inch bolt to secure it. Don't buy wood which is more than two inches thick, but not more than two and a half inches thick. The wood in total is 4 to 4 1/2 inches plus however much Sheetrock is and whatever device is attached to it. The gap between your interior stud and your insulation should be at least 1 1/2 inches.
Approximately 4 inches of Rack Stash stick out from the rack. When mounted, it will be 5" away from the wall. By measuring how far away it sticks out from the hitch on your vehicle, you can add 4 inches. If 5" is close, then it should be fine. Using the same folding method as on your vehicle, you can put the rack away.
In no way am I familiar with an INNO INH305, but the Rack Stash may be able to hold a lot of weight if it is anchored properly. You can use a 2" adapter, but whatever the INNO INH305 is, the unit will stick out further from the wall based on how long the adapter is. I have a Kuat NV four-bike rack with a 2", 2" hitch and it weighs over 60 pounds. I can use the Rack Stash to secure it. Two lag screw anchors and cement anchors were used to mount it in the cement block. I wish you the best of
According to the manual, it weighs approximately 100 lbs. My bike rack keeps my bikes firmly mounted to the wall when it is mounted to the wall. In any case, some caution should be observed since it would be easy to bend the bracket if too much pressure was put on the rack while it was
Selected User Reviews For 1UP USA Rack Stash, Hitch Mounted Bike Rack Storage, Ski and Cargo Garage Organizer, Wall Mounted
It was hesitant for me to order this hanger because of the mixed feedback, but I couldn't find anything else in the short time I had to find one. After receiving and installing the hitch mount inside a shed, I now understand exactly why so many people have issues It says 1 on the sales page, but it really says 2. It is suggested that the product packaging states 1" hitch on a 25" hitch. The packaging of the product that is being shipped has a 25" hitch right on it, while the good itself has As a result, the product was designed intelligently so that it can be used either in a 1" or a 2" slot. The hitch diameter is 25". The red spacers must be flipped to the 1 with the help of an Allen wrench or hex key. A 25" mode is available. In addition, folks who install the hitch without realizing this will then have to deal with 1 in the future. An opening of 2" falls apart under the weight of a 25" hitch. This manufacturer will need to improve the labeling of their products in order to stop getting such bad The true value is 1.
Can be found in As far as the 25" mode goes, I've found this hanger to be really useful. Installing the product is relatively easy with the included hardware and a drill or impact driver. It grips a 1. 25 inch ball. Thule bike racks easily fit on a 25" hitch, and the hitch pin / adapter storage compartment is generously sized. Due to its nicely machined nature, the (relatively) high price is likely a result of its quality.
Will I need to spend $60 on my Kuat bike rack to get it Not at all. I was able to stand it up against the wall all on my own. But this device makes it feel as though it is always put away in the correct place. It was worth paying the few extra bucks for Rack Stash, and it was worth going with a cheaper option. After reading some reviews, I almost chose the cheaper option, but thin metal and bending products bothered me, so I chose the Rack Stash instead. There is no way that it would flex under the weight of my 3-ton backpack You can bike on the The build is very solid. I was able to insert a rack quickly. It is mounted securely to the wall with three large lag bolts. You can store your hitch in an extra slot. The rack is small, simple, and relatively inexpensive (when compared to the rack you currently have) It doesn't get better than that, does it? Please take note The bracket can be mount directly to a 2" wall stud, but I had to move mine over 1. 5" to the right to give it room to clear the garage door, so I added the scrap 4x4" post to the right. I could have achieved much greater strength if I had just nailed the 2x4" stud to the wall.
My Yakima bike carrier doesn't like to sit up straight and it is an odd shape that takes up too much floor space, plus I have a bunch of bikes I want to hang up for the winter, so I wondered if there was a way to The product not only does that, but it also has places to put the ball hitch and pins so it all stays This is the solution I've been looking for - it solves both my garage storage issues It is important to know where to keep the bike rack as well as where to store There's no doubt that the bike carrier alone weighs about 80 pounds, but it still feels very sturdy and well made. This way - I just updated my post twelve months after it was published It still works as well as it did the day I installed it. The investment has been well worth it.
The thing is really solid, it is a good thing that it is overbuilt. If you are mounting it to a stud, make sure you tighten the screws. You might want to try this When you remove the rack all you have to do is turn around and slide it into the receiver as you turn around facing the back of your vehicle. If this is not possible, then mount on the wall facing the back of your vehicle at the same height.
While it has been hooked to my vehicle, my Yakima bike rack is awkwardly shaped and has occupied my space for a long time. My foot has stubbed on it countless times, and I can't even tell you how often I've accidentally knocked it over. Luckily, now it's safely stored on the wall high enough to prevent people (shorter than 6'6") from bumping I needed to go to the hardware store to pick up the hardware and mounting instructions for mounting to a metal stud/drywall wall, but nothing was included in the package. In my shop, the studs are thin and flimsy, so I used heavy duty snaptoggles rated for up to 200 pounds each to secure it to the drywall. There are a couple of options I considered, such as mounting it to a plywood sheet mounted to the wall to distribute weight over multiple studs or installing wood blocking inside the wall cavity, but I feel more satisfied with it without these Pull-ups are not my cup of tea Obviously, you can't stand up on it or put bikes on it on the wall the way it's mounted, but it's sturdy enough to handle the rack's 26 pound weight. It is incredibly easy to put the rack on and take it off. I'm delighted to finally have a dedicated place where I can keep this!.
It's full of two cars, tools, and storage, and is hardly fit for two cars. There are a lot of things in there that need to be organized. It was my 4th birthday this week There was no place to mount my bike hitch rack. Thank you for the wall mount. I had been looking for one for a long time. As soon as I got it, I did some measuring and testing for how high I wanted it to lift my heavy Yakima hitch, and I installed it on a concrete wall using 1/4-inch tapcons and It took me less than 10 minutes to install everything after I had everything measured. In order to measure the right height for my hitch, I held it up to the wall and used a pencil to mark it on the wall. I was able to do the rest on my own.
What it does is as it should be. A perfect fit for the rack. The mount can be easily mounted on the wall. Make sure you find that stud center before you mount. You may want to back off the screw hitch lock just a bit if you are using the Thule XT so that the expander lock is fully In the event that the expander is even slightly too far out, it is impossible for the rack to slide into In general, the mount and rack are tight fits don't let your frustrations override your rational thinking. Whatever the case, a snug fit is better than nothing at all. A second rack just arrived so I can store my previous rack at a safe height during the winter. The XT is heavy, so it will take two of us to lift it.
As far as the others' reviews are concerned, I have no idea what they are about. Having the same opening as the 2 inch hitch, the 25 unit can be used to haul any trailer. There is no such thing as an error! I was able to fit my Thule 1 1/4-inch Vertex 2 bike rack with just a little bit of It is almost impossible to wiggle after putting the bolt in. It is likely the rest of the reviewers received the 2 inch version, in which case, all they had to do was change it to the 1 inch version. The red guides are flipped over after removing the screws and sliding the screws back into the holes. The blunts are sturdy as is the unit itself, as are the suppled links. It's very clear what has to be done. Although I am very happy with this product, the Rack Stash is just outrageously.
Related Products For 1UP USA Rack Stash, Hitch Mounted Bike Rack Storage, Ski and Cargo Garage Organizer, Wall Mounted
