Square D 9013FSG2J20M4 Water Pump Switch, 20/40 PSI, DPST w/Manual Switch & Low Pressure Cut-Off , Black
Score By Feature
OveReview Final Score
Questions & Answers
In fact, yes. It can either be 115 volts or 230 volts. In addition to a he ground, there are four screws, two line screws and two load screws. When I use 6 post installation, I hook up the 2 hots to each outside post and feed the load from each inside post. In this way, when the switch is closed (off), all voltage is disconnected from the load.
Low-pressure protection is designed to prevent your pump from running if there is no input. If it turns off, it means that it has protected you against it. When that happens, you need to determine what caused the pump's pressure to drop so low, and then you need to restart it manually once you are sure you have enough water We have designed our pumps so that they will never restart on their
Turn off the power at 40# to the factory setting. If you need to adjust it, you can do so.
Selected User Reviews For Square D 9013FSG2J20M4 Water Pump Switch, 20/40 PSI, DPST w/Manual Switch & Low Pressure Cut-Off , Black
However, this is a A replacement pressure switch for the well pump on my property was ordered this year based on my tradition of replacing it every two years. As I attempted to install it, one of the four load/line screws did not break free. In two days it arrived after it had been ordered. In the end, I returned it to Amazon because it had stripped. The new pressure switch arrived two days later, and even though there were a lot of super tight screws, I managed to install the replacement pressure switch without any issues. As someone who has installed quite a few of these, I have never encountered difficulty with the screws coming loose. The only downside is that it seems to be lost in translation.
-Checked the well and there was plenty of water. -The defective product had been posted past the return period. You can buy it at your local hardware store, as they understand it should last for.
An older 1953 well pump was in need of a new switch. There were some minor modifications to be made to the brass nipples to make it It seems to work well. In addition, it shuts down when the water runs out! With the old one, the seals would just wear out and need to be replaced.
There is nothing better than it when it comes to simplicity and effectiveness.
I am now able to cut the power at the pressure switch instead of at the outlet. Tripping the breaker is not allowed.
It is great to have an automatic shutoff feature Prevents the pump from turning on when the fluid is.