cncarbonfiber 8pcs 2.0mm Round Carbon Fiber Tube 2.0x1.0x300mm pultrusion for Quadcopter RC Airplanes

The length is exactly 500mm and is very rigid throughout. There is a slight curve running the length of the piece, but it appears to be around 0. At worst, the holes are 5mm in diameter, and they are not centered. If precision is required, purchase a carbon fiber rod rather than a tube and drill it yourself. The finish on the surface is even. Specifications: br> br>The average stick weight is 7g, /- OD of 2gbr>is 4mm /- ID is 1 for 05br>ID. 9mm (off-center wall thickness must be at least 0. 8mm).

Kimora Floyd

| Jun 23, 2021

These were going to be used in a Kossel 3D printer. In the rods, the holes aren't centered. The rods aren't 100% straight at 100% all the time. Rolling them on a flat surface causes them to wobble. I'm going to send these back.

Aylin McDonald

| Apr 02, 2021

I couldn't seem to locate a pair of stiff pushrods. Mine kept bowing, which resulted in all kinds of strange behavior. These worked flawlessly, are extremely stiff, and are even lighter than the ones I was using previously.

Lyric Bell

| Mar 29, 2021

The rods I received were not 5mm in diameter. Using a micrometer, they were discovered to be closer to 5. This variance is important when working with tight tolerances. Apart from that, the quality appears to be acceptable. br>br>.

London Robinson

| Mar 30, 2021

Solid and dependable!.

Remington Donahue

| Sep 30, 2021

not in the same plane as O.

Emanuel Stephenson

| Jul 07, 2021

There are no issues.

Kalel Conley

| Sep 27, 2021