3M Scotchcast Plus 82003A Casting Tape, 3 Inches X 4 Yards -, Roll Black 1 Count

Unfortunately, that's not the case. DISPOSABLE GLOVES SHOULD BE WEARED. There is no opening to this pouch it is sealed completely. We recommend you wear gloves if you plan to open it. That's not what I did. I will discuss that in more detail There is a mesh roll attached to the roll It is black and sticky, and feels like a rubbery material. It was a cross I had to bear This is a broken piece of aluminum from a tent. The 12 ft x 12 ft pavilion was too big for the space, so I decided to fix it instead of throwing it away. My pieces were glued together using JB Weld metal composite epoxy, which I let In order to act as a "splint," I attached a copper wire to the top the following day.
I then wrapped all of the fiberglass over the piece in Fiberglass Casting Tape, and when it was finished that It was just a matter of submerging the entire cross in water Pour a piece of wood into a bucket of water and soak for 10 minutes It should cure in 15 seconds then be set aside to I was amazed to find out that this stuff comes out You need gloves because if you don't wear them During the second part of the procedure, you will have sticky hands and fingers that are resistant to dirt You need to avoid soap, Goop cleaner, Acetone, lava soap, fingernail remover and raw gasoline. You will make your hands sticky and black with this stuff Eventually, this stuff has to wear off over the next few days If I had Nitrite gloves on, that would have been the best idea Having said that, let's be honest.

Milena Galloway

| Dec 08, 2020

I couldn't set it up. What a waste. A product that still hasn't set after its expiration date. Neither of the two 2" or 3" I purchased were working properly because the are old and had cracked holes. I am also concerned with the fact that the directions are in a foreign language, even though I have already sent precious casts to Amazon. The quality of the work was poor.

Aya Pennington

| Jun 18, 2021

Using this type of product on a regular basis is something I do as a professional. After the second half had set (less than 2 minutes), the roll could not even be used off the roll. A purchase of this would not be recommended.

Salvador Wells

| Jul 01, 2021

In order to make aq finger splint that was not overly huge and cumbersome, I needed a small, effective splint. They did a great job with this stuff. But make two or three spares so that you will always have some on hand. You start to notice that this stuff is drying out as soon as you open it.

Jamie Wang

| Oct 06, 2020

If you use warm water, you have to use it quickly once it is activated. In contrast, if you use cool or cold water you can work with it more easily.

Sabrina Joyce

| Mar 14, 2021

I was unable to use it at all. It was already too hard.

Harrison Garrison

| Jun 30, 2021

There was an area of thin casting in which the original cast needed to be reinforced. The Amazon swooped in to save the day. Roll it on, wet it first, then use it. I let it dry for 15 minutes, and it is ready.

Bentlee WALLIS

| Jul 23, 2020