S-93
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
With almost 39 inches of flexibility, it fits perfectly into the Foredom flexible shaft
Among the videos on the homepage of the Foredom YouTube channel are instructional videos on how to perform maintenance and replace a felxshaft.
Please let me know if the two are compatible
This cable has a diameter of 4mm on the inside and a diameter of 8mm on the outside.
Selected User Reviews For S-93
Please click here. I was looking for a replacement cable for my HF carver after my original cable broke. In one review, it was stated that this cable would work, while in another one, it wasn't mentioned. I uploaded some pictures to show you how to use it with the HF carver. Check out my pictures below to understand how to get it to work. While the HF motor shaft can be used with this coupler, it's a bit longer than the HF coupler by about 5mm. In addition to being irritated by the coupler rubbing on the housing end adapter, it will not screw down enough to accommodate all the threads once the set screw is tightened onto the shaft and the cable housing is screwed back into place. To make this work, the foredom coupler needs to be trimmed Ensure you do not pierce the set screw with this piece when cutting off the piece. Smooth the cut end of the coupler with a file once you have cut it. Now the foredom coupler will be the same length as the trunk. Despite this, however, the foredom coupler does not allow the coupler to reach far enough on the HF shaft because of a slight taper. To bore out the front coupler, you will need to spin a 5/16" drill bit a couple of times. Ensure that you don't drill too deep or the cable will be severed from the bottom end of the hole. As you fit the coupler back onto the shaft, make sure it goes deep enough so that the adapter on the cable housing will be able to screw all the way down. Additionally, the brakes should no longer rub against each other or If you put the cable back together, remember to apply some packing grease so that it is lubricated. In case of an emergency, I am going to order a few more foredom cables. There appears to be more beef on the cables ends, which should give them a longer lifespan. The modifications seem to be well worth it, so I think it's I spent about 15 minutes on it It took 20 minutes from start to finish to get the carver up and running Wishing you the best with your modifications and be sure to keep safety in mind.
One of my friends told me it fit the central pneumatic rotary tool, so I bought it. Nevertheless, this is not the case. Because of the loose screw on the cover, I was able to make it work. As you can see, my picture explains everything.
The installer is easy to use. The part as described is standard. The installer is easy to use. I've already used it several times. Prior to installation, make sure the bearing is lubricated properly.
My Foredom Carving machine takes advantage of it well.
Foredom part for my older model. Quite pleased with it. You should note Perhaps a recommendation to buy a replacement sheath would be helpful too. I haven't looked to see if I also need to replace the sheath on my Foredom since it's been out of commission for two years. My cable package arrived without the cable, so I had to order it separately. That was my mistake but it resulted in the repairs being delayed.
I like that it works.
It's easy to install.
It works and can be used liberally in Greece.