VEVOR Lab Jack 8 X 8 Inch, Lab Jack Stand 88LB Load Capacity, Scissor Lab Jack Aluminum, Laboratory Jack Height Adjustable, Scissor Platform Lift for Physical, Chemical, Biological Experiments Use
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
I do not agree with that The weight of 50 pounds of liquid in a carboy is typically supported by this. This is a very sturdy craft.
What you mean by true flat, in more or less, I do not understand. Within a millimeter, they are parallel to each other.
Selected User Reviews For VEVOR Lab Jack 8 X 8 Inch, Lab Jack Stand 88LB Load Capacity, Scissor Lab Jack Aluminum, Laboratory Jack Height Adjustable, Scissor Platform Lift for Physical, Chemical, Biological Experiments Use
The smallest it can be is 3", and the largest it can be is 12". This is what the listing description says Here are the product parameters for this item - [PRODUCT PARAMETERS] The craft is A process where the oxygen is removed from the air This product has a load capacity of 150 pounds. It weighs 88LB. The following heights are available A3" to A5" This item measures 12" x 12" x 8" [WIDE ADJUSTMENT RANG] Two adjustment points could be found on the lab jack stand. A range of 3 to 12 inches.
With cast parts that are well-built on the elevator, this large and heavy duty lab jack is well made. Stamped metal parts commonly found on lab jacks that are not as well made can bend under heavy loads. In order to siphon the wine into a lower container, I sat this up against 6 gallons of wine. In fact, it is sturdy enough to support a weight of about 48 pounds, even when Taking note of the fact that the way the jack is raised and lowered is the standard screw-nut method is important It is a method that relies on information Using this method is fine if you need to raise the platform with a modest load, but it is nearly impossible for anyone with a 48-pound It is no problem at all to reduce the 48 lb load. lever attached to the knob could work, or if the lever strips the threads, then that might work, too. It depends on who you ask.
This machine will lift 80 pounds without a problem. It was common for me to raise my wave bag to adjust the hook at the top of it. Using thread lock is optional. If not, then you will have to tighten the handle very tight. There should be a longer handle sticking out from the platform and a little less proximity to the.
However, the stand never stays.
There is an issue with the quality of the tabs which support raising the plate. Two of the rods are very loose and could distinguish when lifting the It would have been better built if it were more stable.
It arrived today - my lab jack. My engraver bed lays very flat on the bed and is sturdy. Although it has scratches and nicks all over it, it is still in good condition. The fact that it's under a table makes me happy. If it had been otherwise, it might have posed a problem.
I think it is a reasonable product of good.