Hi Flame 4 Wheel Trolley Assembly, Four Bearing Trolley Assembly for Taller Strut Channel or All 1-5/8" Channel(Pack of 1)
Score By Feature
OveReview Final Score
Product Description
Questions & Answers
There is no doubt that it would be possible to make a punching bag out of In terms of a stop, there isn't one To move the bag, you must block the track with something when it is in use and remove the stop when it is time for it to be moved. If I were punching or kicking the bag, I would be more concerned with the track holding.
Selected User Reviews For Hi Flame 4 Wheel Trolley Assembly, Four Bearing Trolley Assembly for Taller Strut Channel or All 1-5/8" Channel(Pack of 1)
My purpose was to buy a 1/2 ton hoist, so rugged enough to handle the weight was important. We are talking about BEASTS here. I tell you, this is a conservative weight rating. I am telling you,BEASTS. Amazon would like for me to rate them on their "sheerness", but I have no experience with that. In fact, I just gave them five stars on the whole. Oh, and they specifically state that I'm sure the tool would be helpful during busy workshops. Refusing temptation and not lubricating was my choice. As smoothly as if on air, 145 pounds of floor jack and 45 pounds of hoist rolled alongside each other.
This is a great heavy duty trolley - I really like it They ride so high in the channel that they cannot be attached to the middle of it with any fasteners. It doesn't matter how long or how small the screws are, even a #9 deck screw with a washer will do the trick. There are probably other unistrut fasteners which could be used to suspend the strut, but those would result in a lower It is important to keep that in mind when designing your trolley. This tracks. The swearing and cursing didn't pose a problem (after I finished), because I'm just hanging a light door, and the length of the strut is strong enough to support itself and the door from two fasteners at the end -- The only caution is if you are going to use it to hoist heavy items, or if you will be hanging heavy objects. Don't overlook the importance of being.
If you intend to install a linear overhead travel system with these, the P1834eg hangers should be fine. make plans to install some sort of vertical lift, there are many It didn't matter that I used the flattest heads I could find the trolley wheels hit the fasteners nonetheless. In my case, I needed to install the vertical unistrut with hanger shells that are typically used for overhead installations (P1834eg) and that fixed The only problem is that they're a bit expensive. There are about eleven of them at Lowe's for about $11. It's not uncommon for places to charge more than $20 per person.
Despite their strength and precision, I like the way they can be built into a home - A very sturdy elevator with little slop, almost like linear rails with no slanting up and down.
For use with unistrut 1" 5/8, it is very sturdy and well made. Vertically if you plan to use In order for the trolley to ride smoothly, you have to use very recessed bolt heads or counter sinks. My solution was to weld some 90 degree brackets to attach the strut to the wall so that the trolly can move freely.
They seem to be just as good, if not better than the "genuine" brand. There are no complaints about these and I saved $20 by not getting the expensive brand. If you need them and would like to save money, buy them here.
Those wheels roll freely in the strut channel, and it looks as if they will work just fine for my application.
My shop has an electric cable lift installed on the ceiling of the shop using these tools.
Related Products For Hi Flame 4 Wheel Trolley Assembly, Four Bearing Trolley Assembly for Taller Strut Channel or All 1-5/8" Channel(Pack of 1)
